Search:

Date: 17th February 2023
Username: eskamobob1
Full Name: Provided in PM
City, State, Zip: Los Angels, CA
Contact: Provided in PM

Description: Thought I would put out a feeler. I am interested...

I would prefer to not drill the trans if I can avoid it. Do all of the RA starters require that? or is that just for ease of instillation over the stock stud?



I think the only reason im...

Perfect! One part down. As for the starter, I keep finding the same sketchy one listed everwhere. Anyone have any experience with these and/or know if they are the right size for sure?
...

Hey Guys,

I am looking for a decent condition 1986 GLH-S starter + the heat shield. The starter and heat shield on mine are not the OE parts and I keep cooking the wires going to the starter so I...

I can't believe I missed that. I 100% would have bought a decent bit above that price :/

Anyone that's reading and wants to sell theirs, reach out

Well ----! Sorry about the late replies yall. I had figured I would get and email if anyone responded so I didnrt check the thread directly until just now. I was able to source a complete set already...

Hey Guys,

EGR was ripped out of my car and the state needs to see it installed to allow me to finish registration. I am interested in parts or complete system. If I can get a complete working...

Thank you for the clarification on that one guys. I was going to be shocked as hell if the intermediate shift position actual mattered (assuming it was corrected for at the distributor) for knock...

I dont honestly understand what you mean by this. Will the car run with 2 spark plug wires switched? If not, how is the #1 wire in the wrong place?



Lol, yah. Lots of guys say they will do it,...

I had just assumed this car used all imperial fasteners. Is it metric? Would be kinda nice considering all of my specialty wrenches and tools are metric. Also, good to know on the timing.


...

Ok, so I figured out how I can tighten it down (with the engine off, I have just barely enough room to go between fan blades with a 1/2" wrench and just have to be careful not to burn myself). I set...

I havent pulled the plugs yet. Most of my tools are burried right now so I probabaly wont get the chance to for a few days here still.

So it is entirely possible to be too advanced and be outside...

Im actualy doing it right now. I cant see the timing mark at all though (kinda suprised the engine seems to run well when warm if the timing is [i]that/i] out). Anyone mind verifying it at least...

Hey Guys,

I have been trying to find a good mechanic in my area (anywhere in socal if you have recommendations) to no avail so it looks like I have to tackle this myself. Here are my three...

Sorry for the double post, but this seems like the best place to ask. Any mechanic recommendations in socal? I would prefer south OC if possible, but I can travel if needed.

Sounds good! I just sent him a message to get some more info. Thank you very much for the information.

Is this chapter still active? I just picked up a GLH-S and would love to meet up with yall if so