Search:

Type: Posts; User: dr_amx; Keyword(s):

Page 1 of 6 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    The site says that 1.5" should be subtracted for each hiem joint. Since the current center to center on the track bar is 46" then a 43" bar would be correct with room for adjustment. The current...
  2. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    This is still a good parts list at speedway for anyone else wondering. I will also buy a similar setup for the panhard bar. Thanks for all your help!

    Part number list:
    910355-42.....Aluminum...
  3. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    I installed the exhaust and I did no massaging. The bolt if from a exhaust previous to my ownership.

    I wonder what to do then. Maybe I should try partially boxing the panhard and mount to see if...
  4. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    So I have been thinking about this. If my track bar was bent then the axle would be justified to the drivers side. It must be the trackbar mount or the static panhard bar that is bent for it to move...
  5. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    Thanks, that is good info. I think I am going to go with something approximating the poly bushing solution "track bar made with 7/8" DOM, 0.156 wall steel tubing." If I order the correct left hand...
  6. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    Does anyone have a picture or specs on what the CSRacing panhard bar looked like? It appears that I will need to make a bracket for the body side and then decide how to change the interface of the...
  7. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    Do you (or anyone) know if there are any springs available still that will work? I have a full set of KYB struts/shocks I will be installing. Not good stuff I know but better then the 140k stuff that...
  8. Replies
    15
    Views
    6,272

    Re: Spirit R/T rear axle tight on drivers side

    My car has stock spring to the best of my knowledge. I suppose a fella could chop the bar and take out the offset needed and weld it back up.
  9. Replies
    15
    Views
    6,272

    Spirit R/T rear axle tight on drivers side

    Hello,

    I am looking for help on solving my offset rear axle on the Spirit R/T. I picked up some new 225/50/16's for the car and now I am really rubbing on cloverleafs. It had 205/55/16 on the rear...
  10. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    "The higher the number, the more lean you are running." That makes me feel better. Guess I need more boost, lol. Thanks!
  11. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Oh, I was thinking that 14 was the safe spot. I guess I have it backwards. The Innovate AF gauge reads constantly. I was watching it as I accelerate so part throttle not WOT.
  12. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    I finally got around to changing the regulator. I set the pressure back to about 44psi without the vacuum line. I also put in a new AFR. The AFR is going down to 11-10 when in a little boost. Do I...
  13. Replies
    3
    Views
    9,677

    Re: 1991 Spirit Reverse light wiring missing 5spd

    Well I believe I have found the grey connector which the wire enters and does not exit. Are pins still available for these connector or is a bone yard my only hope?
  14. Replies
    3
    Views
    9,677

    1991 Spirit Reverse light wiring missing 5spd

    Hi All,

    As the title says my reverse light connector and wiring are missing. I have pulled back most off the covering on the wiring around the battery area and I am not finding signs of it...
  15. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Thanks again Todd!

    Ben
  16. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Here is why I asked the question about the fitting and the o-ring position. http://www.fwdperformance.com/Store/Product.asp?IDCatalog=7&ProductID=859 (Name: Fuel Fittings for Universal Regulator Part...
  17. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Thanks!
    Ben
  18. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Measured the fuel pressure last night. 42psi. The AccuFab also showed up but I still need to order some fittings. How thick do these washers need to be? With the 14mm adapter, is the o-ring near the...
  19. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    I don't know the current fuel pressure. I will have to check. Since you guys have verified that the accufab works on a stock rail I will likely do that. Lots of little things to cleanup on this car....
  20. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Is it possible to put a stock FPR back on the car and let the CPU handle the tune? Or am I already out of the range of a stocker at this point?

    TIII
    -57 trim T3/T4 Turbo from FWDperformance
    -FWD...
  21. TIII Re: Bosch 772 manual fuel pressure regulator replacement

    Sorry All,

    For some reason I did not get the notifications that there were replies here. The application is a 1991 Spirit R/T. The 772 is the only part number I can see on the top side of the...
  22. TIII Bosch 772 manual fuel pressure regulator replacement

    HI all,

    I am looking for a replacement for the Bosch 772 manual fuel pressure regulator. I could go the FWD performance route of a new regulator and fuel rail but I am wondering if there is a...
  23. Replies
    3
    Views
    18,402

    For Sale 1991 Dodge Spirit R/T

    Date: 23rd July 2018
    Username: dr_amx
    Full Name: Ben Kjellberg
    City, State, Zip: Mounds View, MN, 55112
    Contact: madmodifier@gmail.com
    Selling or Wanted Price: $4000 pretty firm (trade for a...
  24. Replies
    937
    Views
    220,130

    Re: MNSDAC "Minnesota" meeting

    Are you guys going to have cars in the show? I have thought about going Saturday but I will park my spirit in the spectator lot.
  25. Replies
    937
    Views
    220,130

    Re: MNSDAC "Minnesota" meeting

    Yeah I noticed your avatar. It looks sweet. Hope that I will see your X some day if I have not already. Are you going to the nationals in Kenosha?
Results 1 to 25 of 145
Page 1 of 6 1 2 3 4