Price change $3500 OBO Need the money more than the car but I will not give it away. Call or text 734-755-1338 or email sammyk48162@yahoo.com samuelekenney@yahoo.com If you pm or post on this...
Type: Posts; User: slowneon; Keyword(s):
Price change $3500 OBO Need the money more than the car but I will not give it away. Call or text 734-755-1338 or email sammyk48162@yahoo.com samuelekenney@yahoo.com If you pm or post on this...
Date: 06th May 2016
Slowneon
Samuel Kenney
Addison MI 49220 Tipton MI 49287
734-755-1338 or samuelekenney@yahoo.com
$4000
89 Shelby CSX VNT with 122710 miles on it.I don’t have the time...
2 or 4 ply gasket would be fine. I had a copper one that didn't want to seal. You should consider the arp SS manifold to head studs just in case its got to come apart down the road. Oil feed comes...
6 and 7 bolts is in reference to how may bolts hold the flywheel on, not the front pulley. Also 97 and up switch cam sensors back to the sensor and the back of the head. Most likely it is a 7 bolt...
Dash assmbly has to come out. Its not to bad just take your time and take pics so you dont have to remember where everything goes.
You really need to clean that garage up its pretty messy
I would check the ground wire should be on the cross member. Also you should have sure your getting a good 12 volt supply to the pump. If you have both that its more than likely the pump starting to...
4.3L requires 60 to 66 psi fuel pressure to open the poppet valves on the injector spider. I had one that did the same time would not start with out starting fluid had low fuel pressure. I replaced...
Fuel pressure should be 60 to 66psi key on engine off
When you click the Mark this fourm read nothing changes. Ok i take that back it does change from dark blue to light blue. The folders dont change not use to the red folder is there any way to get...
I would but i like to get mine for about 1k cheaper. Yes Im and cheap bastard Its a nice looking neon good luck with the sale
I prefer timkin bearings. Many because most are mfg in USA, Canada or Japan I do check because I have had to many parts from china fail the most recent was a water pump on my neon with only 8500...
It saddens me to hear this news. Nate was a great guy. He would always lend a hand if needed. I didn't know him well but talked to him several times at SDAC or a few other times when he would just...
The one i took off i just had to beat with a hammer after removing the two screws. Just like 135sohc said they fill up with water and rust up solid making a pain in the butt to get off
She got a set a while ago.
Here is a couple http://www.turbo-mopar.com/forums/showthread.php?t=46609
If you have access to a obd II scanner hook it up and see if any modules are present on the bus. If you can communicate with the pcm see if there is any stored codes. If you cannot communicate with...
I got in a the group buy for the Billet 6061 Carrier bearing fixture for equal length drive shaft. I paid for mine and seemed like a few days later there it was in my mailbox :thumb:
Got mine today It a nice piece
So is that $90 shipped or is shipping extra?
Make sure the transmission are the same between the car. Meaning if the car is a 5spd make sure the axle you get came out of a talon/eclipse/laser with a 5spd trans it does matter.