Waiting on pics from someone else right now. Will be back in touch...
Type: Posts; User: James Neidig; Keyword(s):
Waiting on pics from someone else right now. Will be back in touch...
Do you have the center trim bezel that runs from the stereo to the ashtray? Mines black. It's in good shape, but I want an original spare as I am drilling mine for a two step boost controller.
I am looking for a set of front belts for my 88 Shelby Z. Grey in color. Mine are frayed a tad.
Also looking for the plastic boots that cover the bottom of them. Grey also.
I would also...
Ok, how about $200.00 for the entire seat and door panel package?!? Someone come to beautiful Central PA and get them...need the floor space in my shop! Still have the rebuildable turbo...$80.00...
Very nice collection. He has a few Ferrari Mondials...been looking for a red vert model, but the red one he has is a hard top. Kind of odd in the collection though...Mondials are not rare and not...
Cmon...are there so many great interiors out there that no one needs one? :) Someone make me a reasonable offer...
They were all part of what was in it when I bought it (used). I had an 87 Shelby Z (bought new) and thought they were the same...maybe not... At any rate, the color matches and they are great...
Thanks Polygon. I am open to shipping them, I just figured it would be cost prohibitive and still turn people away. Any takers interested if I ship?!?
Bump... Any takers???
I have an entire light gray cloth interior for a Daytona. Enthusiast driver seat with matching passenger seat, rear seats, and door panels. All are in very good condition. Driver seat has NO tears...
Thanks again to all. I believe my decision to go forged is the right one.
This is pretty much a mid-life crisis car (I'm 38) so it's main use will be fair weather driving with the occassional...
Thanks everyone. I spoke to Mike at Forward Motion today. I am going to pull it down and measure the bore with a good bore gauge. He can get me JE's and rings to work with the bore I have. I will...
I may be a bit off on that, as the machine shop did wait to bore it until they had the pistons on hand, so they may have bored it off of the piston dims. I guess now I need to know what clearance I...
One more question... my machine shop simply took stock bore and added 20 thousanths to it when they bored it. Will a set of 20 over pistons be fine or will I need to go back through the whole...
Just found the post on the JE's and replied to him. Thanks for the input. I am pulling it back out to change the clutch and turbo anyway....so what's a few more bolts to turn?!? :)
I am interested. Why were they only used for 1000 miles?
I see the locks are included, are the wrist pins as well?
I am in Central PA (Sunbury) so shipping should be minimal.
So I rebuilt my 88 TII Shelby Z from the bottom up. Stock forged crank cut 10/10, Clevite Bearings, TII rods, MP perf head gasket, 804 injectors, block bored 20 over... I plan to run a stage 3 SMEC...
Are these polarity sensitive? I bought an oval one to match my oval harness, but the little internal 'ears' do not line up. If I shave them off, it will insert, but I need to know if I will toast...