That was a good question. I pulled the cap, cleaned the contacts a bit, no carbon tracks. However the rotor looked pretty bad and I couldn't get it off the shaft so I had to carefully break it....
Type: Posts; User: 87glhs; Keyword(s):
That was a good question. I pulled the cap, cleaned the contacts a bit, no carbon tracks. However the rotor looked pretty bad and I couldn't get it off the shaft so I had to carefully break it....
Hello-
Been having a problem with my GLHS (bone stock) misfiring around 2200rpm. Idles fine, and runs fine once I get it up around 2800rpm or so.
I have no fault codes.
I know there are...
Hello--
Been having a periodic problem with my starter during stints of damp weather, followed by cold (<32F). Sometimes it will spin and the Bendix won't catch, and then works fine after a couple...
Appreciate all the info. I installed a set of KYB's with new bumpers and upper bearing caps, found both Konis still had oil but the gas was long gone.
The stock GLHS springs fit fine, though I...
Well, I checked out the Konis at FWD, they go for about double the cost of having all four of mine refurbed.
My question here is does anyone have any experience as to if there is an off the shelf...
Hello. I'm needing to know if there's a contemporary off the shelf alternative to the stock front Konis, that could utilize the GLHS springs. My struts are tired and need to be rehabbed ($$$$), and...
What wires came in the kit for your car, and did you have to do any mods to attach them, or were they all plug-play?
I've asked FWD about this, no reply. I have an oddball wire on my passenger...
Which wires did you guys replace? The one on the PS firewall is obviously an important one. The only others I'm aware of are the ones on the PS motor mount, which has clips, and the two leads that...
Hello. I just repaired my firewall to fuelrail ground strap today after having some odd driveability problems and noticing it had broken--
Anyway, FWD sells an upgrade kit made of stinger...
Maybe someone here can prove/disprove this--there was a rumor awhile back that Leno owned a GLHS Charger but then sold it off--any truth to this? Is there an article or episode of JL Garage showing...
The fuel gauge in my GLHS has never read right, tops out just above 1/2 on a full tank.
I've had the stalk out three times, it tests fine outside of the tank, plugged into the harness. Sensor...
Thanks for all the info--
So, by restrictor, you're referring to the port where the high-pressure line screws in? Looks like it's been drilled to a specific size--
Do I also need to exchange...
Well, my post from yesterday on this subject seems to have mysteriously vanished-- Would appreciate the common courtesy of a PM if one of my postings is removed for some reason, or relocated. Thanks!...
Buy what you can "new" from your local parts chains, and install R134a fittings.
New items would be-
--compressor
--filter drier
--discharge side hose
--gaskets
--condensor coil...
Hello-
I am needing a good front-left (DS) fender for an '86/87 Charger, preferably one off a Shelby Charger due to model year differences in the way it fits up around the A-pillar.
My car is...
Check to see if you have any slop/looseness on the metal rotor that sits under the mag pickup in your distributer. Had a similar issue with my wife's GLHS, which also sat for awhile.
...
Hello-
Local body shop trying to replace my front-left fender, and the replacement they found does not fit properly up at the windshield pillar.
Anyone in the SWLower MI area have an 86/87...
bump!
Thanks for all the input. Going to bite the bullet tomorrow and take it to a body shop and see what they have to say that doesn't involve putting gobs of body filler on with a spatula-- I think I...
Need a pair of them, left and right side, in quartz (white-ish grey). Must be in good shape, no cracks or superglue repairs.
LMK--thanks!
Also still looking for a set of cargo cover hooks for an '86 Charger, in quartz (white-ish grey). Need left and right sides in good shape, no cracks or superglue repairs.
I checked with a guy...
That would have to be a last resort, unfortunately, as most of the radiator shops in this area don't deal with a/c hoses.
I'm looking for some sort of bolt-in replacement--shirley someone else...
I recently took some fender damage to my GLHS Charger (as below). Opinions on repairs? Can this be sytraightened out, or should I be looking for another fender?
...
Hello all-
Rehabbing the A/C system on the wife's GLHS and would like to replace all of the hoses.
The discharge hose appears to be readily available from all of the major parts stores, but...
PM sent