i put Monroe rears on my 87 Shelby charger years ago sensatrac?
Type: Posts; User: boost geek; Keyword(s):
i put Monroe rears on my 87 Shelby charger years ago sensatrac?
keep the chain ends as short as possible on the load leveler i pulled my engine many times with the hood on, saves one extra step of having to put your hood back on, and aligning it to close properly...
lucky you with a small dirt bike,its my dream to be able to ride one again before my stroke i had my nephews yz 80 here what a blast to ride! if i still had it i would move the clutch lever to the...
Randy how did you make out today? i should have mentioned i attach the flat plate chain ends to both ends of the head removing crank pulley as mentioned is a great idea also ! kudos to you for...
cut the head off a belhousing bolt and cut a slot into it to fit a screwdriver and use it as a stud to line up the engine to the belhousing the stud can be removed with a screwdriver
similar to this; ...
kms tools used to sell a cheap load leveler turn the crank handle to add tilt front and rear of the engine i always left the hood on the charger good for you for even trying to do it with 1 hand!
if my memory serves me right don't swirl heads use a longer valve than a G head?,mixing the 2 can lead to problems, I did this once on my first G head I shaved the bottom of a lash adjuster to make...
Hi Randy!, to correct my post Simon only ran 2.5 not 2.2 was there such a thing as 2.5 forged cranks? watching that heavy van launch was a cool sight to see!
I agree with Randy on the timing belts many of us were using cast cranks me included 2.2 TBI crank failures were unheard of even Simon couldn't break one and he could break almost any thing lol
on my G had I lapped big valves onto stock seats just to see the ring on the seats from the big valves then opened the seats and bowls to the ring line with a die grinder, worked great never dropped...
I think swapping headgaskets would be a nightmare without the pins I always had to temove my head studs to be able to lift my heads off even on an egine stand, thats with the crappy ARP tapered...
windows 10 sux !,I had to reset my computer to get it going again I mis EX P,never had a problem with xp
what are the best brands out there?, will one off a CTD work, as they come apart and and can be cleaned? the new owner of my car continues to have problems tit the tps, last one cost $80
looks like my stock '87 piston when it let go, pretty sure detonation broke mine, go forged i m o
sounds so good again at idle!
now to buy a new battery an sell this thing
its notch towards handle it runs again! it quit last summer, wouldn't even turn over or prime the fuel pump.there was a melted plastic spade fuse an melted fuse base and we replaced the...
I removed my chip without paying attention to its position duhh! thanks in advance!
jeff is an awesome seller, shipped a glove box door before receiving the money order, the door looked new awesome seller!, a pleasure to deal with!
thanks everyone getting one from turboSOB
pm sent thanks!
Date: 12th July 2016
Username: boost geek I need a blue glove box glove box door in good condition for my 87 Shelby charger shipped to V2P 5X4 B.C. Canada PM me if you have one thanks!
ifthe oil fill cap is off will the engine blow smoke out the valve cover? if so maybe cracked ring lands
I thanks for asking Randy!