Post here what you will havbe forsale at SDAC
Ill have a 5spd Van Kframe with arms and sway bar B/O
Upper 2 Piece intake painted viper blue with matching V/C
Other tidbits i have figured out yet
Upper isnt ported.
Printable View
Post here what you will havbe forsale at SDAC
Ill have a 5spd Van Kframe with arms and sway bar B/O
Upper 2 Piece intake painted viper blue with matching V/C
Other tidbits i have figured out yet
Upper isnt ported.
All Parts are for a 2.2L 89 Daytona Shelby T-top
one used, good TII radiators
A555 rebuilt in 2001 (have receipt) with 6K miles
Shifter cables for above trans
Stock exhaust manifold
T-top felt strips, used but very nice
All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
CSR Electric water pump
Factory Radio, with equalizer
Windshield washer bottle with good pump
2 drivers side axles
1 passenger axle with carrier bearing
several wiring harnesses
1 computer from FWD (will have to see which cal it is)
1 flywheel lightened by JEGS machine shop
one retractable cargo cover
one lower nose ground effects
1 clockspring
1 radiator overflow tank
cast lower control arms (from Spirit RT)
2 dummy axles to protect wheel bearings
Eibach (0800.250.0450) 8" x 2.5" I.D. Coil-Over Springs, brand new in box
Tons of brackets, and switches and other stuff I forgot about to pilfer through!
Are there specific rules for the swap meet? I have a bunch of stuff I can bring up, but dont have a booth...
Omni GLH Hood
GLH gfx and air dam
GLH fog lights
GLH rally lights
Omni/Horizon fenders
82 Rampage fenders
I am VERY interested in the hood! But only if no clear coat problems or dents. Looking for one for Matchbox.
Various boxes of Harbor freight small tools...screwdrivers, flashlights, etc.
Like new 2.2 valve cover...cant remember if it says turbo
Front door panels for 4 dr L body with one rear one...passenger side I think
P body and L body gauge overlays
A few nearly new tires
Couple of good alternators
Front of a 89? Daytona with door trim...Shelby? I will ONLY bring if someone says they are very interested...$50 for this
I have new/like new lower intercooler hoses to sell. Picked them up at Rosin when i was down there for consulier parts, They must have got them with the motor package and never used them because they have never been clamped onto a turbo/intercooler. No hose clamp marks. Have all factory markings and part numbers, dusty and need some cleaning but would be good for a restoration.
I asked JT about selling stuff Tuesday but hes super busy I'm sure, but I'm wondering too. I can about fill the lebaron with stuff I'll never use and would rather sell cheap than box and ship. Maybe a yard sale on slow hotel nights, lol.
If we're registered, we're good for the swap meet. I'm bringing a few things...:
SRT4 injector cover - $5
SRT4 slave cyl (new) - $10
SRT4 / Neon complete airbag set – driver/pass/covers/sensor box - $40
TI or III coolant tank. $5
Actron Timing light - $10
1pc TII VC (black wrinkle w/ silver) - $20
1pc TII VC (black gloss w/ silver) - $30
TII airbox w/ filter - $20
TII lower IC hose - $20
rearview mirror - $1
Silicone couples (not the ebay kind), small - $5
Large “Y” reducer / 35 degree bend silicone coupler (neve used)- $15
87-91 Daytona rear tail center section - $5
93+ lebaron front turn signals - $5 for pair
TU “Z” turbo brackets (have 2) $5 ea
Aftermarket aluminum coolant tank - $5
84-86 Daytona/Laser boost and message center - $10
87-89 Daytona/Lebaron boost and message center - $10
Good stock clutch disk - $10
J and H body shift boots (80s style) $5 ea.
Stock 87 Shelby Lancer 5spd computer/LM - $50
Vibrant vac block - $10
Custom vac block w/ fittings - $10
Boost only (for diesel) AutoMeter Carbon Fiber boost gauge - $10
TIII Timing gear – prototype - $20
TIII Oil cap – stock - $10
TIII Oil cap – aftermarket aluminum - $10
TIII timing gear – crank – prototype - $10
TIII cam gears - $50
TIII Rods (4) - $50
TIII headbolts (torqued once) - $10
TIII tensioner / mount - $30
TIII A/C Bracket - $30
Vibrant boost Controller - $30
Bulbs – new in package 1141 - $1
LED bulbs - $1
568 leather knob - $10
SRT4 shifter assm - $20
568 base - $5
New aftermarket trans mount - $5
Narrowband Autometer Carbon Fiber A/F ratio: $5
12 button navigator replacement buttons – enough to repair 6-7 Navigators with spare “whoops” buttons - $30
DEX-77 Amplifiers / wiring - $50
21 factory lugnuts (no fancy caps) -$5
Fender mount coil - $10
Head mount coil - $10
Sandblasted bare TB - $1
Cylinder leakdown and compression gauges - $5 (missing fittings)
New Valve spring compressor - $10
87-89 Traveller - $5
Spearco lic plate surround - $5
If someone would take it all, I'd let the hood, air dam, gfx, fog lights, and rally lights go for $250. I can bring it to Carlisle, but it has to be picked up since I cant bring it inside the fairgrounds.
T-top felt strips - are they still available? Are the OEM or aftermarket. I understand the OEM ones have a metal strip inside?Quote:
Originally Posted by shelbymopar89
I'd also like to know if you still have the following:
All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
1 computer from FWD (which cal ?)
I sold everything today except the computer, it is an 88/89 stage 5. It is located at the positive impressions booth if you are interested. I do have some of the rubber only felt strips at home (new)Quote:
Originally Posted by omniac
Ok thanks for the update. i already have the rubber only felts and was looking for OEM items.Quote:
Originally Posted by shelbymopar89