-
Not running right
Hey, I've been doing some preventative maintenance on my '89 Chrysler Lebaron T1. Changed out the water pump, replaced belt, had altenator rebuilt and car was running fine. Put car back in garage and found a fuel leak in the 5/16" fuel line so I replaced that. Start car up and checked for leaks and everything good except check engine light is now on, engine running a little rough and won't go any higher that say 3000 rpm's. It says code 13. A map sensor problem right ? How do I check the sensor ? I checked the vacumn lines and the electrical socket going to it.
Thanks
-
Re: Not running right
A code 13 is going to be a vacuum line issue 99% of the time. Double check that you have everything routed correctly. I would guess that it's not since it's in limp mode. Sometimes I can get condensation in the lines when it's cold and that will throw a code 13 too.
-
Re: Not running right
Yep, go;)t it fixed. It was a vacumn line.
-
Re: Not running right
Glad to hear that you have it fixed Jim.