I attempted to read through all of the head porting threads in a search recently, and they were great. That said, I still have some questions which may help others. There has been some time since a lot of the really good threads were written too, so perhaps techniques, parts, etc. have evolved in the interim.
That said, I went to work for a couple of hours on a head today. It's an old junk head which I did some very, very crude porting on years ago. Some of the intake and exhaust ports are still untouched, so I let into those. I'll be attempting to work on the untouched chambers next. I have another head or two which are also junk, so I have plenty of opportunities to get this right.
After working on this head today, here are my main questions.
1. I'm looking for a head which will make 350HP to the wheels relatively efficiently. How much should I really be looking to enlarge the ports? I have gasket matched the sides and top of the intake port in the pics. I did the same with the exhaust port, but put way less time into it.
I took mine out to the gasket on the side. and maintained that to the short turn/valve guide. I took the top to the gasket line and aimed to match the curve in the bottom to 90% or better to the short turn.
2. A lot of the pictures I've seen on here make it look like way more was removed from the top of the intake port than just going to the gasket. Are my eyes deceiving me, or are they really that high? If so, do guys just cut out the gasket, or get a custom one?
3. The bowl of the intake port took a long time to get remotely decent looking. All the pictures I looked at seemed to show a round bowl without the stock ramp on the one side. Am I going about this correctly?
I tugged the bowls out sideways after I had my throat cut for +1 valves. then cleaned up behind the valve guide. I tried to get the back wall as smooth and straight down as possible.
4. The bowl area seems pretty large, and in the pics you can see that I have a little bit of a pinch point in the middle of the runner to take out still. Should I be going that wide in the first place?
measure your first point at the gasket sides at the exit. and then measure in there. take it out to that size.
5. Any tips for deshrouding the valves in the chamber?
I layed my top of the chamber out about 5-6MM. around both valves. the little cut out at the point was almost gone. I had the machine shop cut the sides to fit the head gasket ring.
Then polished everything. I left a set of used valves in the head when i did this so i didnt nick the seat area.
Hopefully we can get a good discussion going on this like we did in the two piece porting thread. I learned a ton from that, although I still need to get my top half welded up from going through it. Thank goodness I'm practicing with junk this time...
http://www.turbo-mopar.com/forums/at...id=63741&stc=1http://www.turbo-mopar.com/forums/at...id=63742&stc=1http://www.turbo-mopar.com/forums/at...id=63743&stc=1http://www.turbo-mopar.com/forums/at...id=63744&stc=1http://www.turbo-mopar.com/forums/at...id=63745&stc=1http://www.turbo-mopar.com/forums/at...id=63746&stc=1http://www.turbo-mopar.com/forums/at...id=63747&stc=1http://www.turbo-mopar.com/forums/at...id=63748&stc=1http://www.turbo-mopar.com/forums/at...id=63750&stc=1http://www.turbo-mopar.com/forums/at...id=63749&stc=1