Printable View
Hi Team, Looking for help with my 1987 Dodge Shelby GLHS. Where do you buy new rear drums that has the wheel bearings section? Question, does the center section press out of the drum as all I see and have received from Rock Auto are drums with no center section. Do I press that center section out and onto the new drum?
Yes the drum and hub separate. I have used a block of wood and a small sledge. May have to use some heat...
You can also just buy a new hub as well...
Yep. They're not a press fit, but rust has other ideas.
only Chrysler sold drums with hubs pre-installed
and
you need to know BEFORE you start trying to knock stuff apart..
Chrysler "swedged" the studs.. this means the shank of the stud gets hit with something like a chisel to knock a little steel from the stud down over the face of the drum .. THIS holds the two pieces together
you need to grind that little bit of metal away on each stud BEFORE you try knocking the studs out
if you don't it will enlarge the holes in the hub enough that when you go to install the wheel you WILL knock the stud into the drum..
and once tight .. if you get it there.. the studs will likely spin in the hubs when you try to remove the wheel
the hubs from an 89-90 rear wheel disk brake car can and will interchange with what Chrysler put in your back drums and there will be no need to fart around with "swedged" studs
and.
the hubs from an 87-88 rear disk set up.. WILL NOT FIT
Thanks All for the information. I am on my way to resolving this.