SMEC cal for 88 TII on an Ostrich
Hey guys, trying to burn a cal to an Ostrich and for some reason it isn't being recognized or more specifically, it isn't working. I did confirm the Ostrich can take a cal by flashing one for my Lancer. Also verified the cable by ohming each pin, but I guess a bad wire could cause an issue.
We were working from the 89 cal since there isn't a turbonator 88 cal I have found. Is there an 88 cal somewhere available or is there something uniqtyou have to do when flashing the cal to the Ostrich? I tried through MPTune and directly with the EMUtility and did not have any luck with either. Also confirmed the cable orientation.
Can someone provide some direction or let me know if there is something I may have missed?
Re: SMEC cal for 88 TII on an Ostrich
yes you use 89 stuff for all smec's if you want turbonator features.
not sure why its not working. did it run the lancer?
Brian
Re: SMEC cal for 88 TII on an Ostrich
Well the flash of an LM cal to the Ostrich worked, but I didn't have a second SMEC car to confirm if it is the SMEC. Haven't ruled out the cable or a bad SMEC, but wasn't sure if I needed to use a different base cal or not and this confirms that. Now just need to confirm the SMEC and/or cable.
Kinda on a side note, where do you make changes to pumping efficiency, spark advance, etc., with a SMEC? The cal I was reading had 100 entries with just linear value selections and only a few actual graphs. Never done a cal for a SMEC so unfamiliar territory.
Re: SMEC cal for 88 TII on an Ostrich
Quote:
Originally Posted by
minigts
Kinda on a side note, where do you make changes to pumping efficiency, spark advance, etc., with a SMEC? The cal I was reading had 100 entries with just linear value selections and only a few actual graphs. Never done a cal for a SMEC so unfamiliar territory.
Start with the V19.6 codes even if you plan to use 2 bar map with stock injectors.
http://www.turbo-mopar.com/forums/sh...-SMEC-codebase
Re: SMEC cal for 88 TII on an Ostrich
yeah start with turbonator 19.6. when you load whats closest to your setup into MPTune, it should be layed out similar to the turbonator LM stuff.
PumpingEfficiency is Fuel->Modifiers
Spark tables are in Spark->Normal Advance.
Brian
Re: SMEC cal for 88 TII on an Ostrich
Thank you guys, Harry for the link. It will be tested soon, but the base file is where I was messing up. This was the one I needed!