Re: turn signals not working
Quote:
Originally Posted by
mrchuck
It`s a 2 pin vss, I tested the continuity on Circuit C7, VSS WT/OR Wire to Instrument Cluster WT/OR Wire located at the Instrument Cluster R/S 14 Pin Connector Cavity 5 and i have continuity. Then i tested cavity 5 to top terminal of the disconnected speedo connector and i have continuity.Then i disconnected the speedometer connector at the rear/center of the cluster circuit board, the two 14 pin cluster connectors stay plugged in and with the key on probe the ignition and ground terminals of the speedometer connector, and i got battery voltage, I think the speedo is bad ,but the gears that i speak of are from the inside of the speedo not on the sensor. I do have continuity & battery voltage to the 3 pin connector on the speedo. I have this posted to Turbo Dodge too and i was getting help from NAJ overthere.
https://www.turbododge.com/threads/turn-signals-not-working.1256080/#post-4523340
-
Maybe I am missing it, but what I don't see is you checking for zero ohm pulses on the Speed/Distance sensor itself...
Re: turn signals not working
Fixed , Bought a new Vss and gear for the Vss put the speedo in from the 94 lebaron works great now
Re: turn signals not working
Quote:
Originally Posted by
c2xejk
Maybe I am missing it, but what I don't see is you checking for zero ohm pulses on the Speed/Distance sensor itself...
I was just following what NAJ was telling me to try on the Dodge Turbo forms :
https://www.turbododge.com/threads/t...2#post-4523380
Re: turn signals not working
Quote:
Originally Posted by
mrchuck
fixed , bought a new vss and gear for the vss put the speedo in from the 94 lebaron works great now
fantastic!!!!