Racing this car in less than a month, in need of a one piece intake ASAP will travel. Located in Al. Thanks.
Printable View
Racing this car in less than a month, in need of a one piece intake ASAP will travel. Located in Al. Thanks.
Isn't the only difference the charge temp sensor? Just drill & tap a T1 intake.
I had one that was ported, and gave it away last year.
Yup, if you have a TI intake manifold, just drill and tap.
I absolutely would drill and tap , I think I need to explain better. I picked up a common block from T.U. and forged crank, rods ,pistons, new head, new turbo, and the list is miles long. But that motor will not be done in the time frame I need it. So that leaves me rebuilding the short block that was in the car previously In less than a month. That's where the intake comes in my original is being used for the common block being built and leaves me short a Intake for the short block. So I am in desperate need of anything that will cross over.
You should be able to fine a 1 piece easily, I have several but shipping to US from Canada is NUTS. If desperate LMK.
You're in Cullman? There's a bunch of us in Huntsville, one of us should have one, let me check around and we should be able to round one up.
If you pm me your address ASAP, I can have one out to you today.
I've got a bare TI one on the shelf. I can drill and tap it if you want, it'll take ten minutes. Cover shipping, it's yours.
Thanks everyone for the help on the intake. If yall are interested in following the story of the car we post updates on my youtude channel.
https://www.youtube.com/channel/UCe8..._as=subscriber