36-1 wheel ring for the common block 8 valve crank

Date: 27th November 2017
username: tryingbe
full name: harry lui
city, state, zip: mesa, az 85204
contact: tryingbe@yahoo.com


This is what you need if you plan to go megasquirt/microsquirt on your common block 8 valves.

Looking for $50 + shipping. I have ONE left, no plan to make more. If you even remotely thinking about going to MS, buy it now.

You'll need to fully welded to your crank and have it balanced.
You'll also need to make your own crank sensor bracket.

This is what you'll be receiving, one of the ring. This part is tested on 8 valve common block pulley only.

http://www.thelostartof.net/tryingbe...e/36-1ring.jpg


examples

spot welded to the crank
http://thelostartof.net/tryingbe/dod.../36-1crank.jpg

What's the inside diameter of it cut like that?

Approx. 7.025 inch I.D.

Dang, that wont fit my crank pulley.. free bump!