Rob scores, very impressive sir. I'm a fan, admittedly - early american exotic, and twin turbo no less. not a big deal relative to the new breed (bit of a slouch compared to current tech), but 20 + years ago it was one impressive whip.
Printable View
Rob scores, very impressive sir. I'm a fan, admittedly - early american exotic, and twin turbo no less. not a big deal relative to the new breed (bit of a slouch compared to current tech), but 20 + years ago it was one impressive whip.
Albeit ugly lol, I'd rather have a Delorean ;)
Hello Guys! Haven't been here in a while so this is just a little update after a couple of years.
Attachment 63542
Attachment 63543
Attachment 63544
250 WHP @ 6100rpm Naturally aspirated 3.4 liter iron heads
Great to see you post again. It's been too long.
Yep, its been a while! Glad you are good!!
Same here. Any more videos of your car in action? I loved watching those whenever you would post.
That is a bad --- machine. Great n/a numbers too.
I was going to. Before going to the track I was doing some fine tuning and I broke an axle. I replaced both axles and then I broke the trans!!!
Attachment 63545
https://youtu.be/iK4jyu5SFpg
This is me in my Abarth chasing a student in a McLaren.
Wow. It was really cool to see him in that side view mirror after you passed.
What is the install height on those springs? I don't see beehive LS setup.
What throttlebody? Have any pictures of the entry into the intake runners?
Attachment 63546
Attachment 63547
Attachment 63548
As far as the springs I used racing small block chevy springs and I had to machine the seats to fit them.
I'm using a TPI 1000cfm throttle body with dual 58mm blades and the intake runners are designed for high volume and velocity.
If you look at the runners they start very wide on top and they progressively narrow to match the head inlet valve opening.
I chose the square design instead of the round for more flow and volume.
Injectors were relocated 6 inches higher for better fuel atomization.
I made a kit consisting of the intake, CNC ported heads with oversized valves and a camshaft to complement the intake and heads.
Bottom end is stock.
Oh and the exhaust was also upgraded. stock Y pipe vs stock.
Attachment 63549
https://youtu.be/o7a7_ZcC2jk
You can hear it here
https://youtu.be/dayXz0arXZ0
https://youtu.be/H_Ggmtb8K2I?t=394
https://youtu.be/apPx7Tu3Q9E?t=291
Found some videos at the track with the 2.8 Pump up the volume!