Adding a sensor to Megasquirt
Hi all.
I am adding a fuel pressure sensor to MS3X. It's a .5-4.5v 0-100psi sensor, and I have it wired to SpareADC. I am looking through the manuals trying to figure out how to create a gauge and a datalog output for it.
Any help would be greatly appreciated.
Thanks.
Mike
Re: Adding a sensor to Megasquirt
Re: Adding a sensor to Megasquirt
Re: Adding a sensor to Megasquirt
Thanks, Guys. I will let you know tonight if this all works. Lots of family activity today.
Also had my Innovate wideband controller finally die last night. I ordered an AEM, and hoping that it will be as easy to calibrate as people say.
Re: Adding a sensor to Megasquirt
Quote:
Originally Posted by
contraption22
Thanks, Guys. I will let you know tonight if this all works. Lots of family activity today.
Also had my Innovate wideband controller finally die last night. I ordered an AEM, and hoping that it will be as easy to calibrate as people say.
If you're using a 4.9 sensor unit, there shouldn't be any calibration of the sensor. Thank goodness there's no more of that "free air" nonsense.
Re: Adding a sensor to Megasquirt
Quote:
Originally Posted by
cordes
If you're using a 4.9 sensor unit, there shouldn't be any calibration of the sensor. Thank goodness there's no more of that "free air" nonsense.
Mine didn't require calibration. Just screwed it in, and started it up...
Re: Adding a sensor to Megasquirt
Wasn't so much worried about calibration of the unit itself, but calibrating TunerStudio to read the same as the WB display. Turns out, it was easy as pie.
Re: Adding a sensor to Megasquirt
Re: Adding a sensor to Megasquirt
What sensor did you go with?
Re: Adding a sensor to Megasquirt
For the fuel pressure sensor, I am just tapping into a 0-5v sensor that is used for my AutoMeter fuel pressure gauge. For the 02 sensor, I went with an AEM 30-4110.