I'm sure we can work it out, would just cost more with shipping. csxtra and others have used with quaiffe with no issue.
Printable View
I'm sure we can work it out, would just cost more with shipping. csxtra and others have used with quaiffe with no issue.
Sounds good. We can figure it out later.
1. Rdnoel86 L
2. Karlak G
3. eski A w/Quaife
4.
5.
6.
7.
8.
9.
10.
1. Rdnoel86 L
2. Karlak G
3. eski A w/Quaife
4. turbo2point2 L-body
5.
6.
7.
8.
9.
10.
OK, this should be enough to get the ball rolling so I'll contact them to confirm. If anyone else wants in, PLEASE add your info to the list ASAP!Quote:
1. Rdnoel86 L
2. Karlak G
3. eski A w/Quaife
4. turbo2point2 L-body
5.
6.
7.
8.
9.
10.
Quick question about ABS. Can I remove ABS ring(?) from my current axels or can DSS provide new axels with ABS ring?
I need to cancel my participation to this group buy at this moment. I had to put my R/T in storage for a while (read atleast few years). Sorry about that.
Hi JT, have you confirmed pricing? Also assuming we got the required number of commitments tomorrow, when we would need the full money?
Thanks.
Jt,
Please put down for a set.
Thanks
I'm in for a set of mini van axles. Auto trans if that matters.
Axle length...
If i’m too late just let me know.
1. Rdnoel86 L
2. Karlak G
3. eski A w/Quaife
4. turbo2point2 L-body
5. jcronk23 - G Body
6.
7.
8.
9.
10.
Sent from my iPhone using Tapatalk
I think I copied the wrong list. As I think #3 dropped out?
Sent from my iPhone using Tapatalk
Yes eski dropped out. Updated below, Anyone else in!?
1. Rdnoel86 L
2. Karlak G
3. turbo2point2 L-body
4. jcronk23 - G Body
5. ajakeski - Minivan/Auto (need to discuss/check length)
6.
7.
8.
9.
10.
Here is what I found for MV axle specs. I haven't pulled the ones in my van yet to compare, but should have them out soon.
Before you pull the axles out, please measure the distance in the van as follows:
-engine centered left to right (check plunge if needed)
-van on level ground at ride height
-measure straight distance from inside face of hub to face of seal housing, both sides (I thought I had a sketch but cannot find it)