Tab Content
Dan H's Activity
About Me
My Vehicles
Tab Content
  • Dan H's Avatar
    08-09-2019, 11:02 AM
    Dan H replied to a thread Sci/FTDI cable issues in EFI Tuning
    I don't think either should have any effect on the issues you are experiencing. They are only needed for protection if you are using the cable to...
    18 replies | 579 view(s)
  • Dan H's Avatar
    08-03-2019, 09:59 PM
    Dan H replied to a thread Sci/FTDI cable issues in EFI Tuning
    If you want a quick test that might work without any soldering... assuming you can get a good enough connection just by holding it in place. Take...
    18 replies | 579 view(s)
  • Dan H's Avatar
    08-03-2019, 09:47 PM
    Dan H replied to a thread Sci/FTDI cable issues in EFI Tuning
    I'll resist asking where it came from. I'm guessing it doesn't pass the cable test in MPSCAN or MPTUNE, whichever has it? Where you jump the RX...
    18 replies | 579 view(s)
  • Dan H's Avatar
    07-30-2019, 09:12 PM
    Dan H replied to a thread Sci/FTDI cable issues in EFI Tuning
    Sounds like you have every correct. If you have the right Com port selected in MPScan but it displayed generic in the lower corner you can just...
    18 replies | 579 view(s)
  • Dan H's Avatar
    07-29-2019, 11:17 PM
    Dan H replied to a thread SBEC injector drivers in EFI Tuning
    Thanks Miles
    8 replies | 323 view(s)
  • Dan H's Avatar
    07-29-2019, 09:42 PM
    Dan H replied to a thread SBEC injector drivers in EFI Tuning
    They are low impedance injectors. A or B was only a reference to my two initial descriptions in the first post. Those were the driver types for the...
    8 replies | 323 view(s)
  • Dan H's Avatar
    07-29-2019, 11:22 AM
    Dan H replied to a thread SBEC injector drivers in EFI Tuning
    Thanks for checking Miles. I'm asking because I received battery offset data for an injector. It has different scales for type A or B
    8 replies | 323 view(s)
  • Dan H's Avatar
    07-28-2019, 01:16 PM
    Dan H started a thread SBEC injector drivers in EFI Tuning
    Which of the following would best describe the factory injector drivers: A) 2 amp Peak, 0.5 amp Hold, 43V Zener Voltage Suppression, 14.0 VDC...
    8 replies | 323 view(s)
No More Results
About Dan H

Basic Information

Date of Birth
January 9, 1981 (38)
About Dan H
Location:
Massachusetts

Statistics


Total Posts
Total Posts
163
Posts Per Day
0.05
Last Post
Sci/FTDI cable issues 08-09-2019 11:02 AM
General Information
Last Activity
Today 08:30 AM
Join Date
10-30-2010
Referrals
1
  • No Listings in the database at this time.