View Profile: Dr. Johny Dodge - Turbo Mopar Forums

Yesterday, 02:27 PM

Dr. Johny Dodge replied to a thread Engine WTB 1987 2.2 Turbo II oil pan in Parts Wanted

wheel lift tow trucks put a nice crease along the length of the pans too .. if the front of the car isn't lifted high enough to stop the pan from...

2 replies | 33 view(s)

Yesterday, 02:24 PM

Dr. Johny Dodge replied to a thread Masi 16V clutch/flywheel differences in Transmission

interesting to know I saw a TC shifter on ebay I think .. noted it was a little different from the usual but I have a question.. looking at...

5 replies | 45 view(s)

Yesterday, 02:08 PM

Dr. Johny Dodge replied to a thread 1988 K-car style LeBaron sedan rear wheel cylinder questions. in Suspension, Brakes, Wheels, Traction

different train of thought.. sometimes.. there IS a use for the local service shop... one wheel cylinder and a new fitting / flare.. MIGHT be worth...

7 replies | 88 view(s)

Yesterday, 01:56 PM

Dr. Johny Dodge replied to a thread Official-SDAC-30-Discussion-Thread in Shelby Dodge Auto Club

I hate to say I think we're experiencing an event that's going to take 3 to 5 years to pass..and we're only a tear and a half into it it well may...

15 replies | 2788 view(s)

Yesterday, 09:23 AM

chromguy replied to a thread Official-SDAC-30-Discussion-Thread in Shelby Dodge Auto Club

Yes there are exceptions for essential work but I heard it is getting tougher as some entering Canada were not following the rules. Last I heard is...

15 replies | 2788 view(s)

Yesterday, 09:15 AM

chromguy replied to a thread 1988 K-car style LeBaron sedan rear wheel cylinder questions. in Suspension, Brakes, Wheels, Traction

That works. If time is on your side, I always try a variant. I remove the rust from the nut/thread/tube and place a drop or two of ATF on the fitting...

7 replies | 88 view(s)

02-28-2021, 02:53 PM

Dr. Johny Dodge replied to a thread Turbos/Intercoolers Garrett Turbine shaft. in Parts Wanted

if it helps , I have a new/old center housing ...casting only , no shaft ..just the new center casting for building a new turbo..

6 replies | 84 view(s)

02-28-2021, 10:47 AM

chromguy replied to a thread Official-SDAC-30-Discussion-Thread in Shelby Dodge Auto Club

Yes please open the borders...

15 replies | 2788 view(s)