Page 1 of 2 12 LastLast
Threads 1 to 20 of 37

Forum: EFI Tuning

This area is for all your tuning topics - fuel, ignition, air/fuel, calibrations, aftermarket efi, etc.

  1.   Sticky Threads  

  2. Sticky Thread Sticky: MPScanDroid

    Started by wowzer, 09-27-2013 05:02 PM
    15 Pages
    1 2 3 ... 15
    • Replies: 281
    • Views: 35,346
    05-20-2019, 05:58 PM Go to last post
  3. Sticky Thread Sticky: MPSciLink

    Started by wowzer, 12-04-2015 03:58 PM
    15 Pages
    1 2 3 ... 15
    • Replies: 285
    • Views: 33,718
    04-29-2019, 03:17 PM Go to last post
  4. Sticky Thread Sticky: MPTuner

    Started by wowzer, 12-08-2009 11:21 AM
    66 Pages
    1 2 3 ... 66
    • Replies: 1,306
    • Views: 136,030
    11-22-2018, 12:04 PM Go to last post
  5. Sticky Thread Sticky: MPScan

    Started by wowzer, 03-25-2010 10:07 AM
    28 Pages
    1 2 3 ... 28
    • Replies: 558
    • Views: 75,825
    08-27-2018, 11:08 PM Go to last post
  6. Sticky Thread Sticky: ECU Tuning Options

    Started by ShelGame, 02-18-2013 11:26 AM
    1985, 1989, 1990, chrysler, ecu, factory, list, module, protocol, sbec, sbecii, smec, swap, tuning
    • Replies: 11
    • Views: 7,016
    02-19-2013, 01:18 PM Go to last post
  7. Sticky Thread Sticky: SMEC 2.5 T1 Fuel and Spark flow charts

    Started by ShelGame, 02-28-2007 12:57 AM
    • Replies: 3
    • Views: 6,037
    08-07-2010, 08:14 AM Go to last post
  8.   Normal Threads  

  1. MPSciLink starting a Group3 Pre-Order

    Started by wheming, 12-24-2017 10:26 AM
    13 Pages
    1 2 3 ... 13
    • Replies: 250
    • Views: 17,835
    05-20-2019, 07:24 PM Go to last post
    • Replies: 5
    • Views: 1,280
    05-04-2019, 11:06 PM Go to last post
  2. MPSciLink possible Group4 Pre-Order Interest?

    Started by wheming, 04-02-2019 01:00 PM
    built, dodge, list, parts, rack, wanted
    • Replies: 5
    • Views: 453
    05-01-2019, 07:22 PM Go to last post
    • Replies: 1
    • Views: 161
    04-27-2019, 12:09 AM Go to last post
  3. G head values for SMEC calibration

    Started by 89CaravanFan, 03-15-2019 06:56 PM
    1986, 1989, 1990, 52mm, block, cals, caravan, downpipe, engine, exhaust, front, fuel, fuel pump, glh, head, injectors, manifold, omni, pistons, project, pump, rail, sbec, smec, turbo
    • Replies: 11
    • Views: 1,020
    04-20-2019, 10:43 AM Go to last post
  4. Turbonator Nitrous Timing retard

    Started by Joe_Van_Duno, 07-11-2014 01:18 PM
    base, cal, computer, dash, engine, nitrous, relay, sbec, smec, timing, tune, turbo, van
    • Replies: 8
    • Views: 1,302
    03-30-2019, 08:09 PM Go to last post
  5. mpscilink 2.7 setup

    Started by Sloride, 12-18-2018 12:07 AM
    2 Pages
    1 2
    • Replies: 20
    • Views: 1,016
    03-29-2019, 01:21 PM Go to last post
  6. Knock threshold

    Started by player1up, 03-18-2019 04:10 PM
    2.4, 2.4 swap, base, engine, forged, fuel, knock, pistons, smec, stock, swap, temp, threads, voltage
    • Replies: 11
    • Views: 1,005
    03-27-2019, 02:36 PM Go to last post
  7. Mpscan gauge selection

    Started by jeff1234, 02-25-2019 01:40 PM
    gauge, temp, timing
    • Replies: 0
    • Views: 283
    02-25-2019, 01:40 PM Go to last post
  8. Chip reader/burner for SBEC chips

    Started by 85lebaront2, 01-06-2019 12:28 PM
    2 Pages
    1 2
    • Replies: 35
    • Views: 1,953
    02-17-2019, 09:48 PM Go to last post
  9. Question Difference between TIII SBEC and SBECII

    Started by DoubleD, 01-14-2019 06:09 PM
    chip, ecu, module, r/t, read, sbec, sbecii, socketing, spirit, spirit r/t, tiii
    • Replies: 0
    • Views: 172
    01-14-2019, 06:09 PM Go to last post
  10. Simulator research

    Started by rgl10, 01-02-2019 12:54 PM
    auto, built, electrical, engine, fuel, help me, idle, ignition, injectors, knock, motor, original, posi, relay, sbec, thread
    • Replies: 7
    • Views: 612
    01-07-2019, 11:23 PM Go to last post
  11. Barometer reading off?

    Started by moparmike70, 12-29-2018 08:38 PM
    air, base, bin., computer, daytona, ecu, engine, gauge, idle, map, map sensor, mechanic, parts, problem, rings, smec, t3, temp, trim, tu, tune, vacuum, wideband
    • Replies: 10
    • Views: 549
    01-06-2019, 12:19 AM Go to last post
  12. Windows 10

    Started by ShelGame, 07-30-2015 07:46 PM
    3 Pages
    1 2 3
    cables, control, list, scan, tu, tune
    • Replies: 42
    • Views: 3,493
    12-30-2018, 12:28 AM Go to last post
  13. Flashable SMEC Module

    Started by krut, 12-24-2018 07:07 AM
    boost, convert, module, parts, smec, socketed
    • Replies: 5
    • Views: 429
    12-27-2018, 12:19 PM Go to last post
  14. GM 3 bar MAP scale constant / multiplier

    Started by iangoround, 08-19-2018 01:19 AM
    a/f, air, boost, ecu, gauge, key, map, map sensor, msd, pressure, smec, stock, tryingbe, voltage
    • Replies: 6
    • Views: 669
    12-17-2018, 10:06 PM Go to last post
  15. Question Socketing the SBEC

    Started by DoubleD, 12-14-2018 04:42 PM
    boostbutton, ecu, module, sbec, sbecii, socketing, turbo
    • Replies: 4
    • Views: 347
    12-14-2018, 07:14 PM Go to last post
  16. SBEC/ SBECII TIII Flashable ECU Chips Needed

    Started by DoubleD, 11-27-2018 04:11 PM
    boostbutton, ecu, module, sbec, sbecii, socketed, starting, tiii, tu
    • Replies: 1
    • Views: 288
    11-27-2018, 07:44 PM Go to last post
  17. TIII Boost Control

    Started by DoubleD, 07-06-2015 01:43 PM
    boost, control, pressure, sbec, sbecii, tiii, tu, tune
    • Replies: 15
    • Views: 2,023
    11-05-2018, 08:37 AM Go to last post

Page 1 of 2 12 LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •