Page 1 of 2 12 LastLast
Threads 1 to 20 of 29

Forum: Engine - Block, Piston, Heads, Intakes

This section is what we call the long block - pistons to bearings, block to head, etc. Post here!

Sub-Forums Threads / Posts  Last Post

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Turbo Cam basics. Hot Rod Magazine

    Started by contraption22, 12-14-2014 09:45 PM
    cam, camshaft, engine, turbo
    • Replies: 2
    • Views: 2,723
    12-15-2014, 03:35 PM Go to last post
  3. Arrow Sticky Thread Sticky: If you think you have oil pressure guage issues-read here!!!!

    Started by turbovanman², 01-29-2008 03:30 PM
    2 Pages
    1 2
    guage
    • Replies: 27
    • Views: 13,991
    05-06-2010, 09:40 AM Go to last post
  4.   Normal Threads  

  1. Swapping valve springs in the car

    Started by Moparman141, 10-15-2018 02:58 PM
    air, cam, compression, cylinder, factory, head, tool, valve
    • Replies: 19
    • Views: 218
    10-19-2018, 03:02 PM Go to last post
  2. Making an 89 Lebaron run in the 12s

    Started by Moparman141, 09-16-2018 08:56 PM
    2 Pages
    1 2
    a568, adjustable, blow off valve, boost, drag, exhaust, front, gauge, head, injectors, intake, intercooler, lebaron, list, manual, mechanic, mph, performance, power, shelby, tires, turbo, valve
    • Replies: 32
    • Views: 1,081
    10-01-2018, 08:54 PM Go to last post
  3. Question 2.2L TII Head Issues

    Started by gtristan18, 09-16-2018 07:46 PM
    • Replies: 19
    • Views: 661
    09-20-2018, 09:49 PM Go to last post
  4. Big intake stock head.

    Started by thedon809, 08-29-2018 09:03 PM
    2 Pages
    1 2
    .63, 2 piece, adjustable, big, body, engine, free, fuel, gasket, glh, head, idle, intake, performance, power, slh, stock, throttle body, trim
    • Replies: 22
    • Views: 878
    09-02-2018, 06:42 PM Go to last post
  5. Type of phenolic for gaskets/spacers

    Started by 135sohc, 08-13-2018 12:34 PM
    • Replies: 13
    • Views: 480
    08-22-2018, 09:15 PM Go to last post
  6. were to get a 005 hg

    Started by hman1991, 04-02-2008 07:25 PM
    3 Pages
    1 2 3
    • Replies: 47
    • Views: 2,011
    08-08-2018, 07:54 AM Go to last post
  7. Cylinder head opinion

    Started by Dan H, 07-27-2018 12:44 AM
    • Replies: 3
    • Views: 266
    07-27-2018, 12:50 PM Go to last post
  8. Cracked Piston What Would You Do?

    Started by cordes, 07-17-2017 06:33 PM
    4 Pages
    1 2 3 ... 4
    5858, big, compression, failure, motor, piston, repair, sdac
    • Replies: 74
    • Views: 7,267
    06-27-2018, 10:38 PM Go to last post
  9. bolt specifications

    Started by jeff1234, 06-19-2018 07:25 AM
    1989, 2.5, block, common block, crank, pulley
    • Replies: 2
    • Views: 240
    06-19-2018, 12:07 PM Go to last post
  10. Engine Teardown, What am I Looking at?

    Started by RJ138, 05-29-2018 12:31 PM
    bearings, boost, compression, crank, cross, cs, cylinder, engine, failure, forged, fuel, gasket, glhs, head, head gasket, intake, list, oil, parts, piston rings, pistons, rebuild, rings, tool, valve
    • Replies: 17
    • Views: 844
    06-01-2018, 12:21 PM Go to last post
  11. Intermediate Shaft Locked Up

    Started by cordes, 04-21-2018 03:15 PM
    gears, intermediate shaft, oil, oil pump, problem, pump
    • Replies: 18
    • Views: 1,113
    04-28-2018, 04:38 PM Go to last post
  12. Oversize valve thread

    Started by Force Fed Mopar, 04-16-2018 02:47 PM
    build, compression, exhaust, head, intake, seats, stock, thread, threads, valve
    • Replies: 10
    • Views: 898
    04-23-2018, 03:25 PM Go to last post
  13. Two Piece Porting

    Started by cordes, 08-14-2017 12:08 AM
    5 Pages
    1 2 3 ... 5
    • Replies: 86
    • Views: 8,017
    04-20-2018, 03:20 PM Go to last post
  14. Running .035" Squish In 8V Cylinder Head

    Started by glhs613, 05-18-2013 11:04 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 103
    • Views: 17,159
    03-31-2018, 09:29 AM Go to last post
  15. Question 782 big fitting

    Started by Nemesismachine, 03-08-2018 11:05 AM
    big, fitting, head
    • Replies: 11
    • Views: 627
    03-13-2018, 09:39 AM Go to last post
  16. long term cam storage

    Started by chromguy, 02-24-2018 12:45 PM
    air, cam, caps, plastic
    • Replies: 18
    • Views: 1,135
    02-28-2018, 07:03 PM Go to last post
  17. 2 piece intake injector change question.

    Started by shelbyplaya, 02-17-2018 11:14 PM
    2 piece, 2 piece intake, fuel, fuel pressure, injectors, intake, pressure
    • Replies: 3
    • Views: 425
    02-18-2018, 08:21 AM Go to last post
  18. 52mm TB Vs 58mm?

    Started by 2.216VTurbo, 02-01-2018 10:17 PM
    • Replies: 14
    • Views: 1,541
    02-13-2018, 02:02 PM Go to last post
    • Replies: 3
    • Views: 473
    01-22-2018, 10:35 PM Go to last post

Page 1 of 2 12 LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •