Correct, it is designed to have the wheel mounted outboard. In the pic above, I welded a ring onto the under drive pulley and used that to mount the wheel.
turbo2point2 Today, 06:39 AMA 2 piece gasket is right about 2 3/4 X 12 7/8, buy material so as many can fit on your stock as possible. Heck, make 4 and sell 2 of them. Once the
2.216VTurbo Today, 12:16 AMI found 18x12x 1/2 thick g10 on the bay. I actually have a machine shop with a water jet 9 miles from my house so shot them a message.
thedon809 Yesterday, 10:45 PMIm thinking more is more. Still theory at this point tho. I'd go an inch (most ebay stuff seems to be metric?) if L body hood clearance wasn't an
2.216VTurbo Yesterday, 10:37 PMAre you doing your own socketing Ian? I might be interested in a I send you two smecs, you send me one back that's soceketed and has a chip ready to
2.216VTurbo Yesterday, 10:29 PM
· · · 89' press release 82 photos 0 comments |
|
· · · Consulier 99 photos 0 comments | |
· · · Tony Fields 1359 photos 6 comments | |
· · · Knowledge Center 31 photos 0 comments | |
· · · 2006 NAIAS 248 photos 0 comments | |
· · · Tony Fields 1359 photos 6 comments |