Garret
12-14-2006, 04:43 AM
http://i65.photobucket.com/albums/h221/Badachew/PICT0076.jpg
I'll take more pictures of it tommorow, but basically what I did was weld on a piece of 1 inch pipe to a cut off section of the stock panhard bar. Then on the passenger side I added on a 2 inch rod end so I have adjustability. I'm sure you're all wondering why I didn't just make the whole bar 1 inch... well I only had a too short length of pipe in the garage So I made due with what I had. Painting it green made it look all kinds of purdy:thumb:
I'll take more pictures of it tommorow, but basically what I did was weld on a piece of 1 inch pipe to a cut off section of the stock panhard bar. Then on the passenger side I added on a 2 inch rod end so I have adjustability. I'm sure you're all wondering why I didn't just make the whole bar 1 inch... well I only had a too short length of pipe in the garage So I made due with what I had. Painting it green made it look all kinds of purdy:thumb: