Dave
01-13-2006, 10:05 PM
Well I brought home a number of things tonight, 4 stock pistons and rods all together, an intermediate shaft and oil pump both with sheared teeth.
So what to do when you go some wrist pins that need popped out? Of course just slap that oil shaft in the center and pound it out! Works real well... of course it went fine until the teeth, which I plan to grind down so I can use it all the way through, instead we just used a fat pry bar to pop them the rest of the way out.
:) Figured I'd share some input with you guys.
One last thing, does anybody have any good ideas as to how to pop out those dang retainers?? One about took my eye out until I discovered my hand could stop it from flying. :nod:
So what to do when you go some wrist pins that need popped out? Of course just slap that oil shaft in the center and pound it out! Works real well... of course it went fine until the teeth, which I plan to grind down so I can use it all the way through, instead we just used a fat pry bar to pop them the rest of the way out.
:) Figured I'd share some input with you guys.
One last thing, does anybody have any good ideas as to how to pop out those dang retainers?? One about took my eye out until I discovered my hand could stop it from flying. :nod: