Engine Cradle

[Rottie]

Does anyone know of any extra engine cradles or have one out of the car they can do measurements on?

I'm looking to duplicate it for a project.

Thanks!

[jacob mosler]

are you referring to the rear subframe?

[Rottie]

Yep, just the frame. Don't need any of the suspension, etc with it.

[jacob mosler]

Yep, just the frame. Don't need any of the suspension, etc with it.


i dont have any extra, but i do have one out of a car right now.

[Rottie]

It's allot to ask, but is it possible for you to create a drawing with measurements we can use to create a new one?

[player1up]

Series 1 or 2 and does it have a trans / driver side lower removable cross member?

[Rottie]

Series 1

Not sure about the cross member, I'd have to look, but I'll say for this purpose though it shouldn't matter, as it shouldn't change the general dimensions/mounting points right?

[player1up]

yeah, the removable cross member doesn't affect the overall dimensions from what I've seen in pictures. Looks like it's cut and round 4 bolt flanges were welded on where the cuts were made then bolted together.
Not sure why they all weren't like this. FYI I plan on adding this feature to my car. Changing a clutch without being able to remove the trans is a nightmare.

[Rottie]

Sounds like the new one will be with this design as well. Hopefully I can get dimensions of one without pulling mine.

[polopharm]

Who bought the aluminum rear sub frame? I cant remember , but I bet they could get you measurements.

Seems to me with belly pan off you could get most measurements while its still in car.

Sent from my SM-G920P using Tapatalk