Need 80ish pound injectors and 400 pump

[rixsgto]

Like the title says anything close to 80lb out there? Or anyone know of part numbers of something over counter? I'm going for some power, need the fuel to support it. Thanks guys

[tryingbe]

High or low impedance?

[wheming]

I use TrickFlow 95 #/hr. You run 30psi fuel pressure for 80#/hr.
TFS-89095

[rixsgto]

High or low impedance?
I'm going to run megasquirt and I think it'll pick up either..


I use TrickFlow 95 #/hr. You run 30psi fuel pressure for 80#/hr.
TFS-89095
That sounds perfect I think.. thanks

[EaZyE426]

Using MS with low impedance injectors requires an additional board at an additional cost. Probably best to go with high impedance and save yourself the hassle of installing the addon board.

[wheming]

I'm going to run megasquirt and I think it'll pick up either..


That sounds perfect I think.. thanks

For my application i am using the stock smec drivers. So whichever impedence the stock is, these TrickFlow's are stock style replacements (but obviously much higher capacity ).
And FYI, i have run them down to 25psi and they run fine. They give you a bit of room to grow later on if you'll need it.

[EaZyE426]

Stock injectors are low impedance

[2.216VTurbo]

See, told you find the answer here Ric:nod:

[rixsgto]

See, told you find the answer here Ric:nod:
yep, its badass.. thanks again man.

[mock_glh]

Here's my choice, using them now.
http://www.ebay.com/itm/Siemens-Deka-80-LB-High-Impedance-Fuel-Injectors-EV1-Set-4-110324-FI114992-/231258294763?hash=item35d81189eb:g:JmUAAOSw7PBTm0G o&vxp=mtr