Forsale at SDAC post

[Sgt Craig]

Post here what you will havbe forsale at SDAC



Ill have a 5spd Van Kframe with arms and sway bar B/O
Upper 2 Piece intake painted viper blue with matching V/C
Other tidbits i have figured out yet

Upper isnt ported.

[shelbymopar89]

All Parts are for a 2.2L 89 Daytona Shelby T-top

one used, good TII radiators
A555 rebuilt in 2001 (have receipt) with 6K miles
Shifter cables for above trans
Stock exhaust manifold
T-top felt strips, used but very nice
All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
CSR Electric water pump
Factory Radio, with equalizer
Windshield washer bottle with good pump
2 drivers side axles
1 passenger axle with carrier bearing
several wiring harnesses
1 computer from FWD (will have to see which cal it is)
1 flywheel lightened by JEGS machine shop
one retractable cargo cover
one lower nose ground effects
1 clockspring
1 radiator overflow tank
cast lower control arms (from Spirit RT)
2 dummy axles to protect wheel bearings
Eibach (0800.250.0450) 8" x 2.5" I.D. Coil-Over Springs, brand new in box
Tons of brackets, and switches and other stuff I forgot about to pilfer through!

[Nemesismachine]

Are there specific rules for the swap meet? I have a bunch of stuff I can bring up, but dont have a booth...

Omni GLH Hood
GLH gfx and air dam
GLH fog lights
GLH rally lights
Omni/Horizon fenders
82 Rampage fenders

[ATaylorRacing]

I am VERY interested in the hood! But only if no clear coat problems or dents. Looking for one for Matchbox.

[ATaylorRacing]

Various boxes of Harbor freight small tools...screwdrivers, flashlights, etc.
Like new 2.2 valve cover...cant remember if it says turbo
Front door panels for 4 dr L body with one rear one...passenger side I think
P body and L body gauge overlays
A few nearly new tires
Couple of good alternators
Front of a 89? Daytona with door trim...Shelby? I will ONLY bring if someone says they are very interested...$50 for this

[bfarroo]

I have new/like new lower intercooler hoses to sell. Picked them up at Rosin when i was down there for consulier parts, They must have got them with the motor package and never used them because they have never been clamped onto a turbo/intercooler. No hose clamp marks. Have all factory markings and part numbers, dusty and need some cleaning but would be good for a restoration.

[J&H Ryan]

I asked JT about selling stuff Tuesday but hes super busy I'm sure, but I'm wondering too. I can about fill the lebaron with stuff I'll never use and would rather sell cheap than box and ship. Maybe a yard sale on slow hotel nights, lol.

[J&H Ryan]

If we're registered, we're good for the swap meet. I'm bringing a few things...:

SRT4 injector cover - $5
SRT4 slave cyl (new) - $10
SRT4 / Neon complete airbag set – driver/pass/covers/sensor box - $40
TI or III coolant tank. $5
Actron Timing light - $10
1pc TII VC (black wrinkle w/ silver) - $20
1pc TII VC (black gloss w/ silver) - $30
TII airbox w/ filter - $20
TII lower IC hose - $20
rearview mirror - $1
Silicone couples (not the ebay kind), small - $5
Large “Y” reducer / 35 degree bend silicone coupler (neve used)- $15
87-91 Daytona rear tail center section - $5
93+ lebaron front turn signals - $5 for pair
TU “Z” turbo brackets (have 2) $5 ea
Aftermarket aluminum coolant tank - $5
84-86 Daytona/Laser boost and message center - $10
87-89 Daytona/Lebaron boost and message center - $10
Good stock clutch disk - $10
J and H body shift boots (80s style) $5 ea.
Stock 87 Shelby Lancer 5spd computer/LM - $50
Vibrant vac block - $10
Custom vac block w/ fittings - $10
Boost only (for diesel) AutoMeter Carbon Fiber boost gauge - $10
TIII Timing gear – prototype - $20
TIII Oil cap – stock - $10
TIII Oil cap – aftermarket aluminum - $10
TIII timing gear – crank – prototype - $10
TIII cam gears - $50
TIII Rods (4) - $50
TIII headbolts (torqued once) - $10
TIII tensioner / mount - $30
TIII A/C Bracket - $30
Vibrant boost Controller - $30
Bulbs – new in package 1141 - $1
LED bulbs - $1
568 leather knob - $10
SRT4 shifter assm - $20
568 base - $5
New aftermarket trans mount - $5
Narrowband Autometer Carbon Fiber A/F ratio: $5
12 button navigator replacement buttons – enough to repair 6-7 Navigators with spare “whoops” buttons - $30
DEX-77 Amplifiers / wiring - $50
21 factory lugnuts (no fancy caps) -$5
Fender mount coil - $10
Head mount coil - $10
Sandblasted bare TB - $1
Cylinder leakdown and compression gauges - $5 (missing fittings)
New Valve spring compressor - $10
87-89 Traveller - $5
Spearco lic plate surround - $5

[Nemesismachine]

If someone would take it all, I'd let the hood, air dam, gfx, fog lights, and rally lights go for $250. I can bring it to Carlisle, but it has to be picked up since I cant bring it inside the fairgrounds.

[omniac]

All Parts are for a 2.2L 89 Daytona Shelby T-top

one used, good TII radiators
A555 rebuilt in 2001 (have receipt) with 6K miles
Shifter cables for above trans
Stock exhaust manifold
T-top felt strips, used but very nice
All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
CSR Electric water pump
Factory Radio, with equalizer
Windshield washer bottle with good pump
2 drivers side axles
1 passenger axle with carrier bearing
several wiring harnesses
1 computer from FWD (will have to see which cal it is)
1 flywheel lightened by JEGS machine shop
one retractable cargo cover
one lower nose ground effects
1 clockspring
1 radiator overflow tank
cast lower control arms (from Spirit RT)
2 dummy axles to protect wheel bearings
Eibach (0800.250.0450) 8" x 2.5" I.D. Coil-Over Springs, brand new in box
Tons of brackets, and switches and other stuff I forgot about to pilfer through!

T-top felt strips - are they still available? Are the OEM or aftermarket. I understand the OEM ones have a metal strip inside?

I'd also like to know if you still have the following:

All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
1 computer from FWD (which cal ?)

[shelbymopar89]

T-top felt strips - are they still available? Are the OEM or aftermarket. I understand the OEM ones have a metal strip inside?

I'd also like to know if you still have the following:

All T-top trim 2 a pillar, 2 b pillar, two front, and two back
2 T-top door hockey strips, used but in good condition
1 computer from FWD (which cal ?)
I sold everything today except the computer, it is an 88/89 stage 5. It is located at the positive impressions booth if you are interested. I do have some of the rubber only felt strips at home (new)

[omniac]

I sold everything today except the computer, it is an 88/89 stage 5. It is located at the positive impressions booth if you are interested. I do have some of the rubber only felt strips at home (new)

Ok thanks for the update. i already have the rubber only felts and was looking for OEM items.