PDA

View Full Version : KSM knock sensor mount now available!



acannell
04-09-2015, 01:06 AM
This mount is designed to be used with the BMF intake, to mount the stock knock sensor to the cylinder head.

For more information on this design, see this thread (note that the design has been modified slightly since then to be larger):

http://www.turbo-mopar.com/forums/showthread.php?76852-BMF-KSM-development!

The two holes are meant to be used with 1/4-20 bolts.

Bolts are not pictured, but are included.

Drilling and tapping of the cylinder head will be required to mount the KSM.

The stock knock sensor screws right in.

The KSM bolts right up against the head surface, it does not pinch the manifold gasket.

The KSM has not been tested for knock sensor performance and none is guaranteed.

Fitment without clearance issues is guaranteed, however.

Plan installation carefully and make sure you precisely drill and tap the required holes in the head.

The KSM mounts between the #2 and #3 BMF intake flanges with only about 0.050" clearance on its sides to each flange.

The underside of the KSM comes within 0.030" of the manifold gasket. Since the manifold gasket has some freedom of location, its important to confirm that there is clearance to it before drilling and tapping the holes. It may be required to cut away a very small section of the manifold gasket to prevent it from interfering with the KSM installation.

The KSM is CNC machined out of 6061-T651 aluminum.

Its design aesthetics are meant to complement the BMF intake.

The price is $40 shipped to USA.

Please send the paypal to office@exoticelectron.com, with a note indicating you wish to order the KSM.

PM me your shipping address.

KSM's will ship in the first week of May, possibly sooner.

http://i242.photobucket.com/albums/ff197/acannell/20150326_153730_zpsbayefsof.jpg (http://s242.photobucket.com/user/acannell/media/20150326_153730_zpsbayefsof.jpg.html)