View Full Version : ShelGame..do you still do calibrations?
Do you still do calibrations? I sent a PM if you do. Thanks!
Anybody else do them? It is for a 1990 SBEC.
ShelGame
09-27-2006, 10:33 PM
Do you still do calibrations? I sent a PM if you do. Thanks!
Anybody else do them? It is for a 1990 SBEC.
Yes and no. I do, but it seems that my SBEC code mods aren't working and I haven't figured out why. So, no CE Flash or switchable boost for the SBEC right now.
But, I can do a custom cals for the '90/91 T1 or the '89/90 VNT. 3-bar, +20's, +40's, etc. I can also do a T2 SBEC (which never exsisted). You'd have to send me your SBEC, though, if you need it chipped. I don't have any cores. Turn-around on socketing a computer is probably 2-3 weeks, unless I get swamped when people see this :)
SMEC stuff is no problem at all. The CE Flash and switchable boost are working fine...
90Dodgevnt
09-28-2006, 07:31 AM
*sigh* only if you did VNT cal's....:(
Captain Chaos
09-28-2006, 07:34 AM
*sigh* only if you did VNT cal's....:(
Looks like he can.
But, I can do a custom cal for the '89/90 VNT. 3-bar, +20's, +40's, etc....
ShelGame
09-28-2006, 08:02 AM
Sorry, I mis-spoke. I haven't done anything VNT specific other than convert that cal to run the T1 boost control (instead of the VNT boost control) - essentially making it like a T2. I don't have any experience building a VNT cal, and I haven't looked at the boost control routine close enough to understand how it works.
Thanks, Rob. The switchable boost I don't care about , the CE flash; is that when your check engine light flashes when you get knock? If so that would have been nice. I have pulled the chip (my SBEC was already socketed) and have PM'd you, thanks!
ShelGame
09-28-2006, 11:02 AM
On TM.com? I didn't get the PM...
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.