MPTune: Editing Fuel/Air Settings

[mock_glh]

I have a a cal that I'm making up in MPTune. I have the MAP and injectors in ok but the fuel/air settings are all at 14.7. I could manually change them one at a time but it would take forever. I once copied and pasted the full throttle column of these from a Turbonator cal to another one of mine but I don't remember what I did, and I can't make it work now. Is there a special trick to this?

[ShelGame]

You can use the 'INT' button to interpolate between any 2 values in a column. If you want the column (or even a small part of it ) to be the same value, you can put the same value at the top and bottom and then highlight them and everything in between, then hit the 'INT' button and it will fill the column.

Similarly, if you want to go from 12afr at 14psi abs to 11afr at 30psi abs; input those 2 points and hit 'INT' and it will interpolate every value in between.

[mock_glh]

Yes, that works. Thanks.

[ShelGame]

Should have added, you can also copy/paste columns of data from WOT to PT. I'm not sure if you can copy from outside MP Tune (say from another cal or Excel).

[wowzer]

Should have added, you can also copy/paste columns of data from WOT to PT. I'm not sure if you can copy from outside MP Tune (say from another cal or Excel).

you can copy the whole afr setup to excel, mod it and then copy it back. just highlight the columns(s), select the copy button, open excel and paste the data. make changes in excel, copy the changes, highlight the topleft most cell in mpscan afr grid and press the paste button.