PDA

View Full Version : Runs smooth, for a couple minutes



MoparN75
06-11-2014, 06:19 AM
This is my '86 Chrysler T&C I did a T2 conversion on.
It runs nice and smooth for a couple minutes, then is gets rough, and has a frequent miss a cruise speeds. If I accelerate hard it seems to run fine (other than it won't boost as high as it's suppose to).
Plugs, wires, cap and rotor are all new.
OH, the wideband o2 needle will jump up every time the engine misses.
Any idea what may be the problem?

wallace
06-11-2014, 06:50 AM
I would start with the grounds and inspect the injector wiring harness if it's original.

MoparN75
06-11-2014, 01:31 PM
I assumed it would have something to do with whatever only starts functioning after a couple minutes of warm-up. Which I know the o2 sensor does.....

85boostbox
06-11-2014, 10:18 PM
Codes

MoparN75
06-13-2014, 06:20 AM
no codes

85boostbox
06-13-2014, 11:47 AM
Sounds like a fuel problem. Maybe vapor lock problem? I had a similar issue on my old Wagon. Pump would cavitate inside of the tank and it would vapor lock itself if I didn't keep my foot on the gas.

Gearhead24-7
06-13-2014, 03:04 PM
Bad coil?

Sgt Craig
06-13-2014, 06:48 PM
Bad coil?

dont we know that all too well,lol