PDA

View Full Version : Turbo manifolds for V8's



87 charger
01-06-2006, 05:36 PM
Anyone know where I can find turbo manifolds for fords or chevys ? I know some people make their own from headers.For chevys I guess you could just weld a flange on some flipped over block huggers ? I am looking for some true turbo maniflods for either a 302 or a 350.I wanted to put my 455 olds in my RX7 I got off ebay for $100.00 bucks. My father in law has a 302 he wants to give away and grannys speed shop sells the 5.0 swap kit for the RX7. The 455 leaves NO room under the hood :rolleyes: SO now I am a little limited on selection of motors.So if I go with a small block I want try turbo charging one. :eyebrows: :eyebrows: :eyebrows:

ash
01-21-2006, 05:39 PM
Anyone know where I can find turbo manifolds for fords or chevys ? I know some people make their own from headers.For chevys I guess you could just weld a flange on some flipped over block huggers ? I am looking for some true turbo maniflods for either a 302 or a 350.I wanted to put my 455 olds in my RX7 I got off ebay for $100.00 bucks. My father in law has a 302 he wants to give away and grannys speed shop sells the 5.0 swap kit for the RX7. The 455 leaves NO room under the hood :rolleyes: SO now I am a little limited on selection of motors.So if I go with a small block I want try turbo charging one. :eyebrows: :eyebrows: :eyebrows:

Charger:
Go the smaller cubes, but with a 350 bore , destroke it. Make some headers, but use steam pipe bends, nothing fancy, just make sure no dags inside tubes, pick a cam.... any cam with about 114 lobe sep, any cam at all. Polish the heads, standard heads, and put some t04/ t3 turbo netics stuff on. You will have more than enough hp, and will have it all down low too, if you stay with standard heads. Trust me ... i know... just did one too.
Ash