DetroitTurbo
03-03-2014, 01:54 PM
This is not really a group buy but I cant figure out where else to post this.
Designed by Acannell and tested by myself, this gauge plate allows you to place 3 standard size 52.4mm gauges in the dash where the stock boost gauge/alert panel are located. Due to him being busy with other projects like a 1 piece plenum intake and reverse cooling adapters, this project was put on the side burner. All the fitment was tested by me in my 1985 Daytona, and confirmed to be perfect and centered. Standoffs are required to make this plate work, and I will make them for you for a small fee. Standoffs are the white pieces behind the plate that keep it flat with the inside of the dash bezel.
I would be asking $25 per plate, with $5 per set of standoffs.
These plates will be CNC machined from black ABS plastic with a textured or flat surface depending on your taste. This plastic can be painted.
http://i.imgur.com/aa1yD6E.jpg
http://i.imgur.com/g0Bd61u.jpg
In the below pictures the dash bezel is not screwed into place, so it is hanging a bit in the middle, causing the plate to look off. I will take better pictures with the dash screwed in and post them asap.
http://i.imgur.com/OoA3Okx.jpg
http://i.imgur.com/ECJbmnr.jpg
Saying if you want one or not is not a commitment, it is just to find out how many I should make on the first run.
Let me know if you are interested in this product by posting!
Once I get a good measure of the number I should make I will start a sale thread.
Designed by Acannell and tested by myself, this gauge plate allows you to place 3 standard size 52.4mm gauges in the dash where the stock boost gauge/alert panel are located. Due to him being busy with other projects like a 1 piece plenum intake and reverse cooling adapters, this project was put on the side burner. All the fitment was tested by me in my 1985 Daytona, and confirmed to be perfect and centered. Standoffs are required to make this plate work, and I will make them for you for a small fee. Standoffs are the white pieces behind the plate that keep it flat with the inside of the dash bezel.
I would be asking $25 per plate, with $5 per set of standoffs.
These plates will be CNC machined from black ABS plastic with a textured or flat surface depending on your taste. This plastic can be painted.
http://i.imgur.com/aa1yD6E.jpg
http://i.imgur.com/g0Bd61u.jpg
In the below pictures the dash bezel is not screwed into place, so it is hanging a bit in the middle, causing the plate to look off. I will take better pictures with the dash screwed in and post them asap.
http://i.imgur.com/OoA3Okx.jpg
http://i.imgur.com/ECJbmnr.jpg
Saying if you want one or not is not a commitment, it is just to find out how many I should make on the first run.
Let me know if you are interested in this product by posting!
Once I get a good measure of the number I should make I will start a sale thread.