Interest in a 72PPH Holset tune?

[DoubleD]

I had a good chat on the TIII help line, AKA Jackson and learned some important info. With that new knowledge and the other info I have been reading about. I am planning to make a tune for the TIII motors to run 72 PPH or 750cc injectors. This will be a Holset HE341 tune. I will be using MPTUNE to make my calibration and use the turbonator T3 template as a base. I will start with Rob's plus 40%, 3 Bar Cal and then scale it for 72's in the program. I will then build a tune off of that, it will be based on my car and may require some tweaks. with 72's there is the calculated potential to make 450 WHP on fuel. I can not guarantee this number as knock will be a factor at some point. 450whp will run in the range of 30psi on this turbo.This will be specific to my set-up and may require tweaks. Is there interest in the T3 world to have a 72PPH tune? I think 425whp would be fun and safe with all the other supporting mods.

Starting a discussion here...