Compressor housing swap?

[gvare001]

Could a TII compressor housing be swap into a TI turbo. And if so could the TI wastegate be adapted into the TII housing. Thanks, Guido.

[grim]

garrett turbos yes ,u can put the t2 on the t1 .i used the t2 can when i did this . gotta drill a hole for the can to fit . but u cant swap a t2 housing to a t1 mitsu . http://www.thedodgegarage.com/index.html

billy

[gvare001]

Thanks alot, I figure this is the easiest way to go. I'm intercooling my shelby charger, I'm down to the turbo mod. I'm not to sure about building an inlet nipple on the TI turbo, so the housing swap sounds cool to me.

[Clay]

I took an 89 TII Garrett and swapped the compressor housing and the WG can directly to an 86 TI Garrett on my GLHT. No holes to be drilled cause afterall the WG can mounts directly to the compressor housing that you are also swapping over.

Note: make sure when you do this you put a new compressor housing gasket on. they are available cheap (like $1 from TU)

[gvare001]

Thanks for the info!!! Guido.