PDA

View Full Version : TIII Lonewolf Stg 1cams - centerline



Pat
08-03-2013, 10:48 AM
I picked up a pair of LWP Stg 1 cams in a package deal. I know the stock cams were 104/121, but didn't know if there was abetter spec to start with running these cams.

Thanks.

Pat

86Shelby
08-03-2013, 02:52 PM
Best I can say is start with the stock centerlines and experiment from there. I may have done my math wrong finding TDC, but my car ran like poo with them until I tried various adjustments. At one point, the engine idled with 12" vacuum but had enough bottom end torque to break the tires loose just off idle in 1st. I have finally reached a point where it's an acceptable balance of midrange, top end power and idle quality, but have not checked to see exactly where they sit.

rx2mazda
08-03-2013, 06:31 PM
I know there listed in a thread on the other forum by Wallace. I just don't know which one...

Pat
08-03-2013, 07:41 PM
Heard from Lengel...Wallace recommended 110/118 as a starting point. I am going to start there.