View Full Version : T3 2.2 pistons/Rods in 2.4
southkurtk
08-02-2013, 03:31 AM
Can someone please tell me the estimated compression ratio this would achieve. I have searched with no luck.
contraption22
08-02-2013, 08:07 AM
Fairly low after the first couple of revolutions. :) The pistons would contact the head.
southkurtk
08-02-2013, 02:26 PM
Really. The pistons would stick up over the deck? I could have swore I saw someone do this before
Unacceptable
08-02-2013, 02:54 PM
There was a guy running 2.5 pistons in a 2.4 on Neons.org. He was getting 7:1 compression. The quench area is horrible with that setup, so you can't run near as much boost as you'd expect to be able to run.
ShelGame
08-02-2013, 04:05 PM
To run the 2.5 piston/rod, you really need to deck the 2.4 block 0.06"(1.5mm). That pushes the CR up to ~8.5:1 and improves the quench. It's almost identical to the Mexican Stratus Turbo setup.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.