PDA

View Full Version : P5249671 CSX stage 2 but has wiring for internal map. WHAT do I have?


j4278h
01-28-2013, 07:48 PM
So I had a P5249671 logic module with 671 on the connectors. Case had the hole for the map sensor along with the wiring on the board. What do I have? Is it and older lm or what.

Any way to check the board to verify its the 87 T2 setup and not the GLHS.

thanks
cordes
01-28-2013, 08:31 PM
What's the number on the chip?
turbovanmanČ
01-28-2013, 09:22 PM
CSX Stage II computer with underhood MAP sensor. Google, lol.


http://www.turbo-mopar.com/forums/showthread.php?43564-Mopar-Performance-Computer-P5249671

http://www.summitracing.com/parts/dcc-5249671

http://boostedmopar.com/forums/showthread.php?761-Mopar-Performance-P5249671-what-car-is-it-for
j4278h
01-29-2013, 09:40 AM
CSX Stage II computer with underhood MAP sensor. Google, lol.


http://www.turbo-mopar.com/forums/showthread.php?43564-Mopar-Performance-Computer-P5249671

http://www.summitracing.com/parts/dcc-5249671

http://boostedmopar.com/forums/showthread.php?761-Mopar-Performance-P5249671-what-car-is-it-for

this does nothing for me. I already know the part number is for the csx stage 2. My question was why does the board have the map sensor wiring.
turbovanmanČ
01-29-2013, 03:28 PM
this does nothing for me. I already know the part number is for the csx stage 2. My question was why does the board have the map sensor wiring.

What do you mean it does nothing for you? You asked what computer you have, I've listed what the computer is, what it fits and in the Boosted mopar thread talks about the wiring- they used computers with the wiring, its dead, don't use it. :nod:
ShelGame
01-29-2013, 03:32 PM
The MAP sensor connector shouldn't be 'dead'. The pads on the board are connected to the same traces as the pins at the connector. So, you can technically use it either way. If the MAP wires aren't original, they may have been added by someone that didn't want to convert to underhood MAP...
turbovanmanČ
01-29-2013, 06:54 PM
The MAP sensor connector shouldn't be 'dead'. The pads on the board are connected to the same traces as the pins at the connector. So, you can technically use it either way. If the MAP wires aren't original, they may have been added by someone that didn't want to convert to underhood MAP...

Ok, that's good to know, lol.