Pulling Engine/Trans out the top or bottom?

[Kryp2nitE]

Which way is easier on a Spirit?

Any tips on where to connect if pulling from the top?

[turbovanman²]

People do it both ways. I prefer the bottom as I have a hoist. hook on either side of the head then you can angle it up and out.

[Pat]

I've done both...I find up and out easier.

[bigbarneycars]

X2 on the up 'n out

---------- Post added at 12:36 PM ---------- Previous post was at 12:28 PM ----------

OOPZ, Guess I should have added that you need a friend for the R&R on the hood. That and which engine are you playing with? The grab points are way different depending on the # of pistons

[Kryp2nitE]

X2 on the up 'n out

---------- Post added at 12:36 PM ---------- Previous post was at 12:28 PM ----------

OOPZ, Guess I should have added that you need a friend for the R&R on the hood. That and which engine are you playing with? The grab points are way different depending on the # of pistons

Hood is off already, this is a TIII

Thanks for the input all, will let you know how it works out

[shackwrrr]

TIII is a b**** to pull out the top. I've done it twice and every time is was a constant fight.

I had to remove the trans mount bracket and front pulley and I literally had to power through almost bending stuff.

[drewboy404]

i was lucky through the top. Just keep the engine/trans at an angle trans pointed moredown. Slide transmission under mount then drop engine in. piece of cake :) I had to even do it one time cause i forgot to put my main seal in..... opppssssss