ok i pick up junk yard map+brawo

[5sp. mini]

ok after i installed newer map i now don,t have any codes but still never start so now i can work on the no start good news is no codes

[cordes]

Have you checked your cam timing? How about the ign timing? When did it start this non-start business? If you're not getting a code 13 or 14 I would highly doubt that the map is bad.

[5sp. mini]

had a no run with code 14 start then dies now have no more code but no start that code 14 wound not goaway so now it has gone away but need to look farther no start started after installing the new map and barr. i can deal with that will have to look way

[shackwrrr]

Do you have spark? Fuel? Pulsing injectors? Cam spinning and in correct time? Distributor in time? Compression?

[5sp. mini]

timing is on and have fuel it a semi rebuild new head roller cam,rod bearings. need to check for spark now. code 14 was sending it to limp mode,i did a t2 swap useing a 87t11 lm was raining yesterday so i went home car is at my work so i need to take a friend to check to rest, but the list of new part just started, new fuel pump with 55 psi at rail, it has ran but not very long. but kelp getting that code 14 barry has sent me derection on what to check on code 14.

[cordes]

Code 14 is a wiring issue. I know you have instructions, but you can check that you have everything correct with these links.

http://minimopar.knizefamily.net/fault/code14.html

http://minimopar.knizefamily.net/ecu/map_se.html

http://minimopar.knizefamily.net/ecu/lm-1987-t2.html

http://minimopar.knizefamily.net/ecu/lm-1987-t1.html

[5sp. mini]

ok i checked some stuff today i have a set of extra inj. so i went and put them in so before i put them back in to the intake i will check and make sure they are fireing .then the batterty went died so i have to wait one more day, will i have to run a groung wire to the injec. harness to see if they fire?

[cordes]

You can get a noid light to test them from HF for cheap.

[5sp. mini]

the guy i work with has a set, was going to see them spray befor i reinstall, scanner showed relay in pm is working looks like i found why it,s not staying running no fuell after it starts. does the ISM have any fuel init.will see what i fine today

[5sp. mini]

i made a vid. of car but can,t find a host are where to down load, so maybe someone has had same thing going on tried to put it up on facebook didnot seem to load.