were do i find if i have turbo map

[5sp. mini]

the part # is 715-13200 if anybody knows so when ohio rob come out tues day i can have it ready to run

[GLHNSLHT2]

if the part # is red it's a turbo map, if it's black it's an n/a map.

[RoadWarrior222]

Well if you apply +5V and ground to it, and it's an N/A map, the signal wire will be close to 5V, if it's a 2 BAR map it will be close to 2.5 if it's 3 bar it will be 1.7ish... to confirm a lower than 5V reading, put a tire pump with a gauge on it, and give it 14-15PSI, if it's comes up to near 5V it's 2 bar, if it takes 30ish PSI it's 3 bar... then also you can take a vac pump like a brake bleeder and make sure it sucks down close to zero. I've also got a mystery MAP I should get round to doing this to...

Hopefully that's correct, sounds good, but I've just got up.