PDA

View Full Version : TIII Vacuum block and Catch Can setup questions



Kryp2nitE
10-05-2012, 02:13 PM
Just tore out all of the old vacuum lines and wanted to make sure these were the only connections needed.

http://ic2.pbase.com/u12/rmscott/large/19879148.T3VacuumDiagramFSMScan.jpg

From the vacuum block you need to connect Barometer (or just go straight to MAP?), Boost Gauge, Fuel Pressure Regulator and BOV.



The other two fittings on the intake are for the brake booster and the PCV.
Those of you running a catch can, did you just replace the baffle with the can? Or Just vented the valvecovers and plugged the PCV?

Are you running something off of the TB?