Mike M
08-10-2006, 12:25 AM
Allo everyone, I've been looking at doing D-cal/chip burning lately. Anyway, my burner/chips arrived today and I understand almost everything to start burning chips (doing basically stock for awhile before I start playing in D-cal more heavily).
I bought some 27SF512 chips from Moates (direct replacement for AT29C256, which can replace the stock 27C256 chips, so I should be good in that department) - with my burner program I'm prompted for the chip addressing and buffer addressing. With the 512 chip where should I start/end the chip address? And is the buffer addressing the same? I think I'm looking at #s like 0000, 00FF or something like that? I'm not looking at doing two setups on one chip, just a plug and play factory setup.
Thanks mucho in advance!
I bought some 27SF512 chips from Moates (direct replacement for AT29C256, which can replace the stock 27C256 chips, so I should be good in that department) - with my burner program I'm prompted for the chip addressing and buffer addressing. With the 512 chip where should I start/end the chip address? And is the buffer addressing the same? I think I'm looking at #s like 0000, 00FF or something like that? I'm not looking at doing two setups on one chip, just a plug and play factory setup.
Thanks mucho in advance!