PDA

View Full Version : idoling


forged
08-20-2012, 10:32 PM
My Daytona idols at a really high rpm. And when i turn the key to start it.. it sounds normal like the starter.. then it like cuts out and doesn't want to start then it starts all a sudden and idols really high. And if you put it in drive or reverse it dies.. or you have to drive 2 footed.. its an auto t1
cordes
08-20-2012, 10:53 PM
Do you have all the vacuum lines hooked up properly? Even a small vacuum leak in the TI log cars will cause a very high idle.
BoostedDrummer
08-20-2012, 11:21 PM
I had this problem in my charger when I had it. Check the TPS (Throttle Positioning sensor) wires near the throttle body. Mine were loose and the RPMs would shoot up whenever the car started or I came to a complete stop. It was really freaking annoying..
turbovanmanČ
08-21-2012, 12:52 AM
Did you mess something up when you did the fuel lines? Are the injectors properly sealed at the intake manifold? Did you break or improperly route the vacuum lines? Codes?
speedfreek500
08-21-2012, 01:26 AM
injector o-ring get cut? causing a major vac leak.
forged
08-21-2012, 04:28 PM
Nope, it started to do this after i put the +20s in. and now that they are out.. its still doing this.. no codes... only 55 which means no codes
forged
08-21-2012, 05:36 PM
There is a small round like piece that has a hose on one side but nothing on the other.. it says vac on it. It is right under the throttle body
turbovanmanČ
08-21-2012, 05:53 PM
Post a pic as there are a few vacuum lines on the t/b.
forged
08-21-2012, 08:42 PM
It won't let me upload it from my phone. I can send you it?
cordes
08-21-2012, 08:43 PM
It won't let me upload it from my phone. I can send you it?

You can email it to me and I'll put it up or you can use photobucket etc. to host it and then link to it.
forged
08-21-2012, 10:10 PM
http://i56.tinypic.com/651wuf.jpg

---------- Post added at 10:10 PM ---------- Previous post was at 10:10 PM ----------

That is what it looks like
cordes
08-21-2012, 10:12 PM
http://i56.tinypic.com/651wuf.jpg
forged
08-21-2012, 10:42 PM
Yeah.. that is not my photo but that is what I'm talking about. I have the hose going into the left side of the round thing. But not the one on the right coming out of it. Is this what is causing my problem possibly?
cordes
08-21-2012, 10:46 PM
Any vacuum leak on a TI log car is bad news. Cap it off and see what it does for you. I don't recall what that does, but it doesn't look very important.