Passenger Axle Replacement w/ABS

[Kryp2nitE]

Tried searching, found lots of stuff about which axle is best and one post about "If you get a chance check out the axles on an unmodified R/T w/ABS"

Is there anything special when ordering an axle to replace my equal length setup and keep ABS? Was just going to order the Napa replacement for a 93 Dynasty w/ABS (It shows the picture of the saginaw boot)

http://www.napaonline.com/Catalog/CatalogItemDetail.aspx?R=NMD948002_0140497147

(http://www.napaonline.com/Catalog/CatalogItemDetail.aspx?R=NMD948002_0140497147)Part Number: NMD 948002

Thanks!

Chris

[turbovanman²]

I believe the Dynasty axles are different, so use an R/T Daytona or Spirit with ABS.

[Kryp2nitE]

I believe the Dynasty axles are different, so use an R/T Daytona or Spirit with ABS.

Just looked up 93 Daytona w/DOHC and it is the same part #, sounds like thats the one!

Thanks again

[Turbo3Iroc]

The axles are physically the same as non-abs axles but there is a trigger ring on the hub end. I might have one here, want me to bring it to 22?

[Kryp2nitE]

The axles are physically the same as non-abs axles but there is a trigger ring on the hub end. I might have one here, want me to bring it to 22?

Is there a strength difference between OE and a napa if they are both saginaw? If you just have it sitting around I would use it, i will send you a pm. Thank you!

Chris

[Turbo3Iroc]

I didn't notice a difference in strength until I went to DSS axles.