View Full Version : 520 Trans Help
ol"blue
05-28-2012, 09:52 PM
K so had to replace my clutch and figured while the trans was out i would take care of the leaks from when po put in Chrome Moly Transplate.so how does that plate come off?took off 2 c clips and some snap rings then got scared and stopped.been reading/searching and can't find no info on tear down please help turbomopar.
135sohc
05-28-2012, 11:41 PM
http://www.turbo-mopar.com/forums/knowledge.php?title=Drivetrain:Bearing-Plate-Installation
I also sell that snap ring that goes on the ends of the input and pinion shaft to keep everything in place if you would like to replace them.
http://www.turbo-mopar.com/forums/showthread.php?58989-6500980-snap-ring
39866
ol"blue
06-05-2012, 09:31 PM
Thanks so much very good info
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.