A413 fresh rebuild won't shift out of 1st

[GLHSKEN]

OK guys, need possible issues and potential fixes. It's for my Shelby Lancer. Reverse and 1st work fine. No dice when trying to shift out of 1st. New convertor as well. Hughes.

[135sohc]

Just a stock type VB ? If reverse is applying then atleast the rear band servo is working. Do you have a pressure gauge to read line pressures ?

[GLHSKEN]

Stock valve body. No pressure guage. Reeves has one. Waiting for it to finish dripping. Reverse and 1st work fine. rooster tail where it should have been...

[shadow88]

Sounds like a fiarly stock rebuild (?)

So it won't shift out of first?

Correct fluid level?
Is the throttle cable adjusted properly?
Small bits of debris sticking the governor?

[GLHSKEN]

rebuild with extra clutchpack fromn ohio rob, rebuild by R/t
fluid level was correct
Waiting to check governo until it quits dripping

[turbovanman²]

Stuck governor, valve body put together incorrectly or sticking valves. TV adjusted properly? How did you adjust the front band and is it working? Air check the servo.

[GLHSKEN]

TV ??? I have not done any of the work. Novice here...

[roachjuice]

Tv is the cable that runs from the throttle body to the trans. If out of adjustment it will shift late or not at all if it's broke.

[GLHSKEN]

adjusted correctly

[shadow88]

There is a pressure port at the rear of the oil pan closest to the back of the car. This is the governor test port. You can remove the plug and use a rubber tipped blow gun to shuttle the governor valves. This will usually unseat whatever's stuck in there if it's a governor problem.

Also, the 2 governor tubes may not be seated properly, you gotta be very gentle when you're prying them out if you remove the valve body.

[GLHSKEN]

Thanks, will look for the pressure port and the tubes slipped out easily....

[GLHS60]

If it's broKen it shifts early, not late.


Thanks
Randy


Tv is the cable that runs from the throttle body to the trans. If out of adjustment it will shift late or not at all if it's broke.

[GLHSKEN]

LOL thanks randy... I had undone the adjuster completly and tes7ed that befire.

[GLHS60]

Good to hear from you Ken. Let us know what you find.

Thanks
Randy


LOL thanks randy... I had undone the adjuster completly and tes7ed that befire.

[bakes]

This might be a stupid question but it is not a Rev manual valve body and you have it what you think is drive by chance.

[GLHSKEN]

No, stock valve body...

I'll take the 4 day weekend to work on it...

[turbovanman²]

Band adjustment?

[GLHSKEN]

will be checking today... got a bit lazy over the weekend.

[GLHNSLHT2]

at all or just WOT?

[turbovanman²]

will be checking today... got a bit lazy over the weekend.

Understandable.

Loosen the 18mm locknut, snug down the adjuster then back off 1.5 turns, hold it and tighten the lock nut.

[GLHSKEN]

was still lazy, but thanks for the info...

---------- Post added at 07:17 PM ---------- Previous post was at 07:17 PM ----------

at all...

[turbovanman²]

Know the feeling, I have to fix mine, its been 2 weeks now, lol.