Fan blower control swith

[John B]

My '92 Voyager heater/AC fan only works on the highest speed now. I need a blower speed control panel. Please advise me if you can obtain one. Thanks for your help! John B

BTW these are not difficult to pull out and I'll make it worth your while!

[shackwrrr]

when it only works on high its usually the blower motor resistor.

[RoadWarrior222]

I concur.

[turbovanman²]

I concur thrice.

As usual, I can send you one, :nod:

[John B]

Duh. Master troubleshooter me! Thanks for the enlightenment. Where is the resistor located?

[4 l-bodies]

Should be on passenger side of firewall. Remove from underhood. At least that's where they are at on newer minivans and most all FWD vehicles. Many times they just get rusty and stop making electrical contact, but at times they will get hot and melt wire. I've repaired several times for a friend of mine. Every time he buys a different minivan, this seems to always be on the list to repair. A minute in media blast cabinet and it's usually good to go for another 100K miles.
Todd

[John B]

Thanks!

[RoadWarrior222]

Yah, I dealt with one, but I'm not sure it was on a mopar, where the coils and contacts where just rivetted in and pressing together, the damp had got between them and I couldn't clean it up well enough, and they seemed a little loose, and I just forced a sliver of thin sheetmetal between them.

[turbovanman²]

Its right in front of the passenger strut tower on the firewall, looks like brown bakelite with a wire connector pushed on.