PDA

View Full Version : TIII holset with stock computer



91TD_owner
11-10-2011, 09:58 AM
Is it possible to run a holset on the stock computer with out a issue? I have +40, afpr front mount, wideband O2. I have the fuel psi turned way down cuz I'm only spiking 16 and hold 11-12psi.. thanks guys.

tryingbe
11-10-2011, 10:10 AM
What does your wideband say?

91TD_owner
11-10-2011, 11:19 AM
When I stab it in 2nd goes to 10.2 when spiking and 11.6 by redline.. but I mean it was really really rich when I first put injec. and afpr on and adjusted it accordingly till what I have Stated above.. so I have plenty of fuel to support the holset just not sure how its going to act on a stock computer.

Lotashelbys
11-10-2011, 11:34 AM
I ran one with +20s just to see how it would do. Adjusted the AFPR accordingly and it seemed fine at around 12PSI. Just watch your WB and spark advance as the stock computer would run higher spark advance as say a 3bar cal.

91TD_owner
11-10-2011, 12:22 PM
I ran one with +20s just to see how it would do. Adjusted the AFPR accordingly and it seemed fine at around 12PSI. Just watch your WB and spark advance as the stock computer would run higher spark advance as say a 3bar cal. ahh ok thanks jackson that answered my question! What if I can't monitor spark advance?

turbovanmanČ
11-10-2011, 01:44 PM
ahh ok thanks jackson that answered my question! What if I can't monitor spark advance?

Then keep the boost around stock levels or run alky or race gas.

91TD_owner
11-10-2011, 03:41 PM
Oh ok.. cuz it still can detonate even with afr richer than 11.5 right?

turbovanmanČ
11-10-2011, 04:35 PM
Oh ok.. cuz it still can detonate even with afr richer than 11.5 right?

Yes, detonation can still happen with rich and correct mixtures.

91TD_owner
11-10-2011, 05:42 PM
ok... 10psi till I get a 3bar cal then.. well as soon as I get the turbo on there that is. :)