Need TBI rods!

[turbovanman²]

Anyone have any decent TBI rods for cheap? :eyebrows:

[MeandMyShadow]

Still have these, make me an offer.

http://www.turbo-mopar.com/forums/showthread.php?57831-Daytona-CSX-T-Spirit-Shelby-Lancer-Parts&highlight=

[turbovanman²]

Still have these, make me an offer.

http://www.turbo-mopar.com/forums/showthread.php?57831-Daytona-CSX-T-Spirit-Shelby-Lancer-Parts&highlight=

They won't work, need TBI rods.

[135sohc]

Simon I have 1.5 sets laying around and 1 set still installed in an engine block. As is I would not reuse them but if you were having them resized/fresh bolts and cleaned up they would be fine.

[turbovanman²]

Kinda looking for a set I don't need to rebuild. I'll let you know, thanks.

[4 l-bodies]

So your looking for a set of LW rods that have press pin? With or without pistons?
Todd

[turbovanman²]

So your looking for a set of LW rods that have press pin? With or without pistons?
Todd

Yep, need press pin, so LW or whatever. I need 89+ .020 over 2.5 TBI Pistons but that would be like finding a needle in a haystack, lol. I found a set on Ebay but if I can get used for everything, that would be easier, :nod:

[bakes]

I have a set TD TBI rods if that helps.

[turbovanman²]

I have a set TD TBI rods if that helps.

Nope, sorry.

I managed to find some today at work, lol, but if I can get a set with .020 overs, I'd be all over that.

[Pat]

I have LW rods with ARP's and with .020 over swirl cast turbo pistons. Not sure if that will work for you though. Bearings were perfect when the motor was disassembled.

[turbovanman²]

The rods yes, pistons, no, :(

How much?

[Pat]

The rods yes, pistons, no, :(

How much?

$50 shipped to your US address sound good?

The pistons on these rods are perfect. Just slam them in there. If you go from 100 to 93 hp on a TBI motor due to a bit less compression, I wouldn't worry about it. :-)